Chapter
Linksys One Ready Communications Solution
2 | Reset Switch | ||
| |||
| The Ethernet switch can be reset by inserting a pin or paper clip into the RESET opening. If | ||
| the reset switch is held for 10 seconds or longer, the Ethernet switch will be reset to its default | ||
| settings. | ||
|
|
| |
|
| CAUTION: All |
|
|
| lost when you hold the Reset button for |
|
|
| 10 seconds or longer; the Ethernet |
|
|
| switch reverts to its default settings. |
|
|
|
|
|
| When a unit is reset to its default setting, the unit restarts in stackable mode using default | ||
| stacking ports with autonumbering enabled. Pressing the reset button on the master unit of a | ||
| stack resets all units in the stack. | ||
| LAN Ports | ||
| The Ethernet switch is equipped with 24 Ethernet ports. | ||
The Switch is equipped with 24 | |
| network ports, which use |
| support network speeds of 10Mbps, 100Mbps, and 1000Mbps. They |
| can operate in half and |
| enables each port to automatically detect the speed of the device |
| connected to it, and adjust its speed and duplex accordingly. |
In stacking mode, two ports are used for stacking. By default, the stacking ports are 12 and 24.
Ports 11, 12, 23, and 24 are shared with GBIC1, GBIC3, GBIC2, GBIC4 respectively. If shared port pairs are both connected, then the
Chapter 2: Getting to Know the Switch | 5 |
The Front Panel |
|