Linksys SGE2000 manual Placement Options, Desktop Placement, Rack-Mount Placement

Page 13

Chapter

 

Linksys One Ready Communications Solution

3

units to be logically stacked together. It is recommended that multiple Ethernet switches

be mounted in a rack when installed in this manner. Ethernet switches can be physically

placed at different locations; they do not have to be stacked at the same location.

Placement Options

Before connecting cables to the Ethernet switch, first you will physically install the Ethernet switch. Either set the Ethernet switch on its four rubber feet for desktop placement, mount it in

astandard-sized, 19-inch wide for rack-mount placement, or mount it on a wall with the wall-mount brackets provided.

NOTE: The four supplied mounting brackets can be used for either wall mount or rack mount installations.

Desktop Placement

1.Attach the rubber feet to the recessed areas on the bottom of the Ethernet switch.

2.Place the Ethernet switch on a desktop near an AC power source.

CAUTION: Keep enough ventilation space for the Ethernet switch so it does not exceed the environmental restrictions mentioned in the specifications.

Rack-Mount Placement

To mount the Ethernet switch in any standard-sized, 19-inch wide, (each Ethernet switch requires 1RU of space in the rack), follow these instructions:

1.Remove the four front screws on one side of the Ethernet switch. Retain the screws for re- installation.

2.Place one of the supplied spacers on the side of the Ethernet switch so the four holes align to the screw holes.

Chapter 3: Connecting the Switch

9

Placement Options

 

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Release Page Contents Appendix E Specifications Web Utility ConfigurationWhat’s in this User Guide? IntroductionIntroduction Overview Getting to Know the SwitchFront Panel Front Panel LEDsSystem Status LEDs LAN Ports Reset SwitchBack Panel Power PortUplink Ports RPS Port Console PortBefore You Install the Switch Connecting the SwitchDesktop Placement Placement OptionsRack-Mount Placement Wall-Mount Placement Repeat steps 2 and 3 to connect additional devices Connecting the CablesStacking Highlights Stacking Multiple SwitchesInterface, you can change the mode to standalone mode Connecting Cabling for StackingConfiguring the HyperTerminal Application Console ConfigurationSet the serial port settings as follows Connecting to the Switch using Telnet or SSH System Information Switch Main MenuManagement Settings Serial Port Configuration Chapter User & Password Settings Security Settings Chapter IP Configuration To change IP address configuration settings Chapter File Management Reboot System Restore System Default SettingsStack Configuration Back to main menuPort Configuration Help Accessing the Web-based Utility Web Utility ConfigurationViewing Online Help Appendix Linksys Contact InformationUAE Customer Site Survey ˆ No Uplink speed must be greater than 768 Kbps Limited Warranty Appendix C Limited Warranty Industry Canada Statement Federal Communication Commission Interference StatementEC Declaration of Conformity Europe Specifications Vlan Radius DOS MAX Appendix Release
Top Page Image Contents