Linksys SGE2000 manual Federal Communication Commission Interference Statement

Page 43

Appendix

Linksys One Ready Communications Solution

DFederal Communication Commission Interference Statement

This Equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

WARNING: You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.

Industry Canada Statement

The Class [A] digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulation. Cet appareil numerique de la class [A] respecte toutes les exigences du Reglement sur le materiel brouilleur du Canada.

EC Declaration of Conformity (Europe)

In compliance with the EMC Directive 89/336/EEC, Low Voltage Directive 73/23/EEC, and Amendment Directive 93/68/EEC, this product meets the requirements of the following standards:

EN55022 Emission

EN55024 Immunity

Appendix D: Federal Communication Commission Interference Statement

39

Image 43
Contents Release Page Contents Appendix E Specifications Web Utility ConfigurationWhat’s in this User Guide? IntroductionIntroduction Front Panel LEDs Getting to Know the SwitchOverview Front PanelSystem Status LEDs LAN Ports Reset SwitchBack Panel Power PortUplink Ports RPS Port Console PortBefore You Install the Switch Connecting the SwitchDesktop Placement Placement OptionsRack-Mount Placement Wall-Mount Placement Repeat steps 2 and 3 to connect additional devices Connecting the CablesStacking Highlights Stacking Multiple SwitchesInterface, you can change the mode to standalone mode Connecting Cabling for StackingConfiguring the HyperTerminal Application Console ConfigurationSet the serial port settings as follows Connecting to the Switch using Telnet or SSH System Information Switch Main MenuManagement Settings Serial Port Configuration Chapter User & Password Settings Security Settings Chapter IP Configuration To change IP address configuration settings Chapter File Management Back to main menu Restore System Default SettingsReboot System Stack ConfigurationPort Configuration Help Accessing the Web-based Utility Web Utility ConfigurationViewing Online Help Appendix Linksys Contact InformationUAE Customer Site Survey ˆ No Uplink speed must be greater than 768 Kbps Limited Warranty Appendix C Limited Warranty Industry Canada Statement Federal Communication Commission Interference StatementEC Declaration of Conformity Europe Specifications Vlan Radius DOS MAX Appendix Release