Linksys PSUS4 manual Appendix H Regulatory Information, FCC Statement

Page 57

PrintServer for USB with 4-Port Switch

Appendix H: Regulatory Information

FCC STATEMENT

This PrintServer for USB with 4-Port Switch has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment or device

Connect the equipment to an outlet other than the receiver’s

Consult a dealer or an experienced radio/TV technician for assistance

EC Declaration of Conformity (Europe)

In compliance with the EMC Directive 89/336/EEC, Low Voltage Directive 73/23/EEC, and Amendment Directive 93/ 68/EEC, this product meets the requirements of the following standards:

EN55022 Emission

EN55024 Immunity

Industry Canada (Canada)

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe (B) est conforme à la norme NMB-003 du Canada.

Appendix H: Regulatory Information

50

Image 57 Linksys PSUS4 manual Appendix H Regulatory Information, FCC Statement
Contents PrintServer for USB Copyright and Trademarks How to Use this User GuideTable of Contents Common Problems and Solutions USB PrintServer’s Back Panel List of FiguresDriver’s Welcome Connected Protocol Introduction WelcomeWhat’s in this Guide? Introduction What’s in this Guide? PrintServer for USB with 4-Port Switch USB Connector-Type a Getting to Know the USB PrintServerBack Panel Side Panel Front PanelOverview Connecting the USB PrintServer to your NetworkInstallation Installing the PrintServer using the Setup WizardPassword IP Settings Confirmation Windows Driver Installation Driver’s Welcome Select Program Folder TCP/IP 10 Configure Printer Port Setup Tab Configuring the PrintServerProtocol Tab Apple Talk Protocol Tab TCP/IPNetBEUI Protocol Tab NetBEUIInternet Printing Printer Tab Internet PrintingLogical Port Printer Tab Logical PortStatus Tab Printer Status Tab DeviceExit Exit TabInstalling using setup.exe Windows IPP Client SetupIPP Client Configuration for Windows 98, Me, 2000, and XP Internet Printing ProtocolAddPort Changing the IPP Port SettingsUsing IPP Printers IPP Client Setup for Windows 2000 and XPInternet Printing Protocol Windows IPP Client Setup Bi-Admin Installation Bi-Admin ManagementBi-Admin Installation Connected Protocol Starting the Bi-Admin Management UtilityMenu Options Bi-Admin Management Utility12 Printer Status 14 Verify Password TCP/IP 18 Apple Talk 20 Internet Printing 22 Attached Remote Common Problems and Solutions Appendix a TroubleshootingNeed to upgrade the firmware Appendix B About Bi-Directional Printing Appendix C Upgrading Firmware Figure C-1 Upgrade FirmwareAppendix D Windows Help Shared ResourcesNetwork Neighborhood/My Network Places Appendix E Glossary PrintServer for USB with 4-Port Switch PrintServer for USB with 4-Port Switch PrintServer for USB with 4-Port Switch PrintServer for USB with 4-Port Switch PrintServer for USB with 4-Port Switch Appendix F Specifications Limited Warranty Appendix G Warranty InformationFCC Statement Appendix H Regulatory InformationAppendix I Contact Information