Advantech RMD-1150 user manual Condition Checkpoint

Condition	Checkpoint
Picture doesn't appear.	-Check to make sure the signal cable
	is firmly seated in the socket
	-Check to see if the computer system
	Power is ON
	-Check that the brightness control is at
	the appropriate position, not at the
	minimum.
	-Turn off your monitor. Hold down +
	and - Simultaneously while turning on
	your monitor. This will reset your
	monitor and " all mode reset" Will
	appear.
Screen isn't synchronized.	-Check to make sure the signal cable
	is firmly seated in the socket.
	-Check that the output level matches
	the input level of your computer.
	-Make sure the signal timings of the
	computer system are within the
	specification of the monitor.
	-If your computer were working with a
	CRT monitor, you should check the
	current signal timing and shut down
	your computer before you connect the
	VGA Cable to this monitor.
Screen isn't centered.	Adjust the H-position, and V-position,
	or perform the Auto adjustment.
Screen is too bright (too dark).	Check if the brightness or contrast
	control is at the appropriate position,
	not at the Maximum (Minimum)
Screen shakes or waves.	-Moving all of objects which emit a
	magnetic field such as motor or
	transformer, away from the monitor.
	-Check if the specific voltage is
	applied.
	-Check if the signal timing of the
	computer system is within the
	specification of monitor.

If you can't troubleshoot using this chart, stop using your monitor and contact Advantech technical support.

RMD-1150 Series User's Manual 3 3