Bosch Appliances SC3100 manual Radio Status LED Indications

Page 13

SC3100

SC3100 Circuit Board

The battery restore message will NOT be sent by the SC3100 until the charge on the SC3100 Battery has reached a minimum of 11.5 VDC during transmit TX ACTIVE.

Note: The SC3100 battery voltage is only tested when the radio transceiver is transmitting.

Note: The SC3100 internal battery is shipped from Bosch Security Systems disconnected. The installer MUST open the SC3100 enclosure and connect the internal battery connector. It is then recommended that the SC3100 be programmed into the SC9000 computer and brought ONLINE for a minimum of 3 hours prior to installation to charge the internal battery to a sufficient level. The SC3100 internal battery may NOT be charged to full capacity after an idle, no-charge period, such as during shipping from Bosch Security Systems.

2.3Radio Status LED Indications

The Radio Status LED illuminates to indicate the current transmit and receive status of the SC3100 Radio Communicator. This is a bi-color (red & green) LED. It illuminates to indicate the current transmit (red) and receive (green) status of the SC3100 internal radio module. This indication is helpful when sending and receiving signals.

This LED will illuminate red when the SC3100 is Transmitting a signal to the Central Station.

This LED will illuminate green when the SC3100 is receiving any radio signals (Carrier Detect - CD) on the Radio Receiver frequency. This green indication can mean the SC3100 is receiving a signal from the Central Station, is hearing another SAFECOM Radio Communicator in the field, is being interfered with due to a high level of RF noise in the area, or is being intentionally jammed on the RX frequency.

 

SC3100 Operation and Installation Guide

 

 

 

© 2004 Bosch Security Systems

Page 13

90026-201D

Image 13
Contents SC3100 Radio Communicator Operation and Installation GuideSC3100 Contents Contents Safecom Communications Paths Introduction Safecom Telemetry Communications SystemOverview of Safecom Radio Communicators IntroductionSC3100, Full Data Transfer, Radio Communicator Standard Radio Specifications Safecom SC3100 Radio Communicator SpecificationsFederal Communications Commission FCC Notice To Users Federal Communications Commission FCC StatementSC3100 SC3100 Circuit Board Components SC3100 Circuit BoardSystem Status LED Indications Radio Status LED Indications SC3100 SC3100 Pre-Installation Requirements Pre-Installation RequirementsSC3100 Wiring Requirements DC Power Requirements of the SC3100 Radio CommunicatorAntenna Location SC3100 Radio Communicator LocationSC3100 Antenna Types SC3100 Acceptable Antenna TypesSC3100 SC3100 Radio Communicator Installation Installation ProceduresAntenna Connecting Wires to the SC3100 InstallationMain Molex Connector 2 R131XSystem Initialization System Initialization ProceduresProgramming Parameters Dialer Format Dialer ACKDigital Format 90026-201D Bosch Security Systems Manual Initialization of an SC3100 Radio Communicator SC3100 SC3100 Programming Worksheet Warranty Coverage and Duration Warranty Limited WarrantyWhat this Warranty does not Cover How to Receive Warranty ServiceSC3100 SC3100