Bosch Appliances manual Safecom SC3100 Radio Communicator Specifications

Page 8

SC3100

Introduction

1.4SAFECOM SC3100 Radio Communicator Specifications

Size: 4.5" W x 4.1 " H x 2.5" D (11.4 cm W x 10.4 cm H x 6.4 cm D)

Weight: About 1 lb. (0.5 kg) with internal 12VDC battery

Temperature: Operating: -20°to +50°C (-4° to +122°F)

Temperature: Storage: -40°to +75°C (-40° to +167°F)

Operating Voltage: 11 - 15 VDC, 350 mA, from an alarm panel auxiliary power, separate power supply, or external 12VDC battery (11 - 15 VDC, 850mA peak if internal battery is not used)

Internal Battery: 12VDC, 0.8 AHr, sealed gel cell

Panel Indicators: System Status LED and Radio Status LED

Interface: TELCO line from RJ31X jack

12VDC power, flying leads RF cable, RG-58, for antenna Alarm panel TELCO line - dialer

1.5Standard Radio Specifications

Note: Specifications may vary in other frequency bands or with the use of various makes of radio transceiver modules.

1.5.1Receiver

Frequency range: 440 - 470 MHz

Minimum Sensitivity: -113dBm (0.5 mV) for –12dB SINAD

Selectivity: 70 dB at 12.5 kHz Channel Spacing

Frequency stability: ± 5 Part Per Million (PPM)

1.5.2Transmitter

Frequency range: 440 - 470 MHz

Frequency stability: ± 5 ppm

RF output power: 2 watts ± 0.2 W

Deviation: ± 2 kHz ± 0.2 kHz

Modulation: FM

1.5.3Factory supplied Antenna

14-16 inch (frequency specific), rubber duck vertical 1/2 Wave

1.6Notices

1.6.1Copyright Notice

Copyright  2004 Bosch Security Systems All Rights Reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form by any means without the written permission of Bosch Security Systems.

1.6.2Trademarks

SAFECOM is a trademark of Bosch Security Systems. Other brand or product names are trademarks or registered trademarks of their respective holders.

1.6.3Notice

The technical information in this manual has been carefully checked for accuracy and is presumed to be reliable and correct. However, Bosch Security Systems assumes no responsibility for any inaccuracies and reserves the right to modify and revise this manual without notice. Changes are periodically made to the information herein; these changes will be incorporated in new editions of this publication.

Please contact our Technical Support Department to request copies of this publication, technical information, and product support for all of the SAFECOM product lines.

Bosch Security Systems

130 Perinton Parkway, Fairport, NY 14450-9199 Customer Service: (800) 289-0096

Technical Support: (888) 886-6189

 

SC3100 Operation and Installation Guide

 

 

 

90026-201D

Page 8

© 2004 Bosch Security Systems

Image 8
Contents Operation and Installation Guide SC3100 Radio CommunicatorSC3100 Contents Contents Introduction Safecom Telemetry Communications System Safecom Communications PathsIntroduction Overview of Safecom Radio CommunicatorsSC3100, Full Data Transfer, Radio Communicator Safecom SC3100 Radio Communicator Specifications Standard Radio SpecificationsFederal Communications Commission FCC Statement Federal Communications Commission FCC Notice To UsersSC3100 SC3100 Circuit Board SC3100 Circuit Board ComponentsSystem Status LED Indications Radio Status LED Indications SC3100 Pre-Installation Requirements SC3100 Pre-Installation RequirementsSC3100 Wiring Requirements DC Power Requirements of the SC3100 Radio CommunicatorSC3100 Radio Communicator Location Antenna LocationSC3100 Acceptable Antenna Types SC3100 Antenna TypesSC3100 Antenna Installation Installation ProceduresSC3100 Radio Communicator Installation Connecting Wires to the SC3100Main Molex Connector 2 R131XSystem Initialization Procedures System InitializationProgramming Parameters Digital Format Dialer ACKDialer Format 90026-201D Bosch Security Systems Manual Initialization of an SC3100 Radio Communicator SC3100 SC3100 Programming Worksheet Warranty Limited Warranty Warranty Coverage and DurationWhat this Warranty does not Cover How to Receive Warranty ServiceSC3100 SC3100