SC3100
Installation
4.0Installation Procedures
This section describes the installation procedures for the SC3100 Radio Communicator.
4.1SC3100 Radio Communicator
Mount the SC3100 at the location determined from the considerations discussed in Section 3.0. The total weight of the SC3100 is about one pound (0.5 kg) with the internal 12 VDC battery installed.
The SC3100 is normally installed in an upright position in the bottom and inside of the host alarm panel enclosure (see Figure 3).
SAFECOM ANTENNA
CONNECTOR
HOST ALARM PANEL BATTERY
HOST ALARM PANEL |
SAFECOM
SC3100
FACTORY SUPPLIED RF COAXIAL CABLE
SAFECOM SC3100
RADIO COMMUNICATOR
Figure 3: SC3100 Radio Communicator
4.2Antenna
Each SC3100 Radio Communicator unit is shipped from Bosch Security Systems with a 20 in. (50.8 cm) antenna coaxial cable assembly to mount the antenna directly on the host alarm panel enclosure (as shown above). The unit is also shipped with a 2" x 2" antenna mounting
If mounting the antenna directly on the host alarm panel, use the attached antenna coaxial cable assembly to connect the SC3100 radio communicator to the antenna (on the top of the host alarm panel enclosure). See the following figure:
ANTENNA CONNECTOR
MOUNTING WASHER
MOUNTING WASHER
HOST ALARM |
PANEL |
ENCLOSURE |
WITH KNOCK- |
OUT REMOVED |
Figure 4: SC3100 Antenna
| SC3100 Operation and Installation Guide |
|
|
| |
© 2004 Bosch Security Systems | Page 19 |