Adder Technology SV2, MX11800, ADD0026/6, SV4 manual SmartView Installation and Use

Page 19

channels (see section 4.9) then only the active channels will be selected. Otherwise the SmartView will cycle through all channels when using HOTKEYs + TAB.

The hotkey command are summarised below (note that the numbers on the numeric keypad do not form part of a valid hotkey) :

‘HOTKEYs’ and ‘1’ - selects channel 1 ‘HOTKEYs’ and ‘2’ - selects channel 2 ‘HOTKEYs’ and ‘3’ - selects channel 3 ‘HOTKEYs’ and ‘4’ - selects channel 4

‘HOTKEYs’ and ‘TAB’ - selects the next active channel if the SmartView has been set to scan active ports (see section 4.9). Selects the next numbered channel in sequence if the SmartView is set to scan all ports.

‘HOTKEYs’ and ‘A’ - selects autoscan mode where each channel is displayed for the selected time (see section 4.3). To cancel autoscan mode simply select any fixed channel either by hotkey or using the SmartView button.

‘HOTKEYs’ and ‘0’ – switches off the video signal and displays 0. This will cause some monitors to go into standby mode or switch off. The video signal can be re- enabled by selecting a channel.

‘HOTKEYs’ and ‘L’ - disables the SmartView's shared keyboard and mouse and displays 0. The video signal is switched off. If a password has not been set then the SmartView can be re-enabled by selecting a channel. If a password has been set then the SmartView displays 'P' to indicate that a valid password must be entered to unlock the switch. Simply type the same key combination as was set during configuration (see section 4.8) followed by the (enter) key. Note - if anyone has typed at the keyboard whilst in secure mode, it will be necessary to type (enter) first to clear the invalid password, then type the valid password followed by (enter) again.

Examples of common hotkey sequences (assuming CTRL + ALT hotkey option):

To select channel 2:

press ba2 release 2ba

SmartView

Installation and Use

Page 18

Image 19
Contents SMARTView Warranty Safety informationAbout this manual European EMC directive 89/336/EEC Radio Frequency EnergyContents Appendices SmartView configuration optionsIntroduction Key featuresProduct information Package contentsSmartView SV2 version supporting 2 PCs What you will need InstallationMounting the SmartView Connecting your devicesConfiguring the SmartView Configuring your PCsH2e Ee Summary of SmartView configuration optionsSmartView Installation and Use Re-enabling a disconnected PS/2 mouse Other useful installation informationSmartView Installation and Use SmartView Installation and Use Status display Using the SmartViewPower on status Front panel key and remote controllerKeyboard hotkey control SmartView Installation and Use RS232 control Mouse controlCascading SmartViews SmartView Installation and Use Screen saver time delay SmartView configuration optionsDisplay options Autoscan lock on mode and delay time Mouse mode and mouse switching of channels Keyboard hotkey combination Setting a security password Firmware functions version query, mouse restore and resetCascade query code Exit configure modeCycling between all channels or just the active channels A1. Keyboard, monitor and mouse to SmartView Appendix A. Cable and connector specificationsA2. SmartView to PCs 1 to A3. Expansion port pin assignments SmartView 4 port only Appendix B. Problem Solving Mouse causes channel to change SmartView Installation and Use SmartView Installation and Use SMARTView
Related manuals
Manual 34 pages 40.83 Kb