PC Concepts ADSL2+ user manual Image Upgrade Successful, Alarm

Page 93

3.In the Upgrade File text box, type the complete name of the file to be downloaded and loaded to flash, as indicated by your ISP.

The name of the upgrade file must be either TEImage*.bin or TEPatch*.bin, where

*represents any of additional characters, up to a total filename length of 256 characters.

4.In the Username and Password fields, type the information required to log on the ISP's server (if the ISP requires it).

5.Click Upload.

An alert window pops up displaying the following message:

6.Click OK to start the image upgrade.

The file begins downloading from the ISP's server and loading the image into flash. When image upgrade is complete, the following message displays Æ Remote

Image Upgrade Successful...

The system will proceed to reboot itself automatically. Wait 1 minute to allow the reboot to complete, then refresh your browser and log in again to the device. You must refresh your browser and log in again if you want to continue using Configuration Manager.

5.8.5Alarm

You can use the Configuration Manager to view information about alarms that occur in the system. Alarms, also called traps, are caused by a variety of system events, including connection attempts, resets, and configuration changes.

92

Image 93
Contents ADSL2+ Copyright Contents Admin Backup/Restore Configuration 100102 Package Contents System RequirementsAdsl Compliant PPP Support ATM Protocols and EncapsulationsBridging/Routing Support IP ManagementInterface Device managementSingle-Port Adsl Router Front Panel Indicators and DescriptionDescriptions of LED status Four-Port Adsl RouterDescriptions of All Connectors Back PanelConnect Related Devices Page Setup Adsl router via USB Cable Setup Adsl router via Ethernet CablePage Page Page For Windows XP TCP/IP ConfigurationDouble-ClickNetwork Connections icon Page Page For Windows Select Internet Protocol TCP/IP then click Properties Page Page Select Gateway tab and click OK Option2 Configure IP Manually Page Setup Adsl Router via USB Cable on MAC Page Page Page Page Page Compiling the Driver Setup Adsl Router via USB Cable on LinuxLAN Configuration LoginHome HomePage System Mode Quick Configuration Page LAN LAN ConfigurationPage Dhcp Mode Adding Dhcp Server Address Pools Dhcp ServerDhcp Relay Follow these instructions to configure Dhcp relay Page 1 DSL WANATM VC 3 PPP PPP Configuration table displays the following fields 4 EDA Page Ipoa Bridging BridgingConfiguration Enabling Bridging ServicesWAN to WAN Bridging Enable/Disable Enabling Bridgeable InterfacesPage 3 DSL Page Page ATM VC Page RFC 1483 Interface EoA IP Route RoutingPage IP Address Table Page 4 DSL ATM VC Page 6 PPP Page 7 EOA Ipoa Page 1 NAT ServicesRIP 2 RIPPage Select a Send Mode and a Receive Mode Select a metric value for the interfaceFirewall Page IP Filter Page Bridge Filter 6 DNS Blocked Protocols Page Ddns Sntp UPnPUser Configuration AdminCommit & Reboot Committing Changes Local Image UpgradePage Remote Image Upgrade Alarm Image Upgrade SuccessfulDiagnostics Click Submit System Log Port SettingsBackup/Restore Configuration Page Management Control Configuring the ATM Virtual Circuit Autodetect Modes Configuring AutodetectAutodetect Snmp Configuration Click Add Comm Creating CommunitiesViewing Hosts Viewing Global Snmp StatisticsParental Control 103