PC Concepts ADSL2+ user manual

Page 19

Configure IP address Manually:

Step 5: Select Use the following IP address & Use the following DNS server addresses.

IP address: Fill in IP address 192.168.1.x. (x is a number between 3 to 254).

Subnet Mask: Default value is 255.255.255.0.

USB interface Default gateway: Default value is 192.168.1.2.

Ethernet interface Default gateway: Default value is 192.168.1.1

Preferred DNS server: Fill in preferred DNS server IP address.

Alternate DNS server: Fill in alternate DNS server IP address.

You can use ping command under DOS prompt to check if you have setup TCP/IP protocol correctly and if you computer has successfully connected to this router.

For example, USB interface ping to the gateway

*Type ping 192.168.1.2 under DOS prompt and the following message will appear: Pinging 192.168.1.2 with 32 bytes of data:

Reply from 192.168.1.2: bytes=32 times<1ms TTL=64

Reply from 192.168.1.2: bytes=32 times<1ms TTL=64

Reply from 192.168.1.2: bytes=32 times<1ms TTL=64

Reply from 192.168.1.2: bytes=32 times<1ms TTL=64

18

Image 19
Contents ADSL2+ Copyright Contents Admin 100 Backup/Restore Configuration102 System Requirements Package ContentsAdsl Compliant IP Management ATM Protocols and EncapsulationsPPP Support Bridging/Routing SupportInterface Device managementFour-Port Adsl Router Front Panel Indicators and DescriptionSingle-Port Adsl Router Descriptions of LED statusBack Panel Descriptions of All ConnectorsConnect Related Devices Page Setup Adsl router via USB Cable Setup Adsl router via Ethernet CablePage Page Page For Windows XP TCP/IP ConfigurationDouble-ClickNetwork Connections icon Page Page For Windows Select Internet Protocol TCP/IP then click Properties Page Page Select Gateway tab and click OK Option2 Configure IP Manually Page Setup Adsl Router via USB Cable on MAC Page Page Page Page Page Compiling the Driver Setup Adsl Router via USB Cable on LinuxLAN Configuration LoginHome HomePage System Mode Quick Configuration Page LAN LAN ConfigurationPage Dhcp Mode Adding Dhcp Server Address Pools Dhcp ServerDhcp Relay Follow these instructions to configure Dhcp relay Page 1 DSL WANATM VC 3 PPP PPP Configuration table displays the following fields 4 EDA Page Ipoa Bridging BridgingEnabling Bridgeable Interfaces Enabling Bridging ServicesConfiguration WAN to WAN Bridging Enable/DisablePage 3 DSL Page Page ATM VC Page RFC 1483 Interface EoA IP Route RoutingPage IP Address Table Page 4 DSL ATM VC Page 6 PPP Page 7 EOA Ipoa Page 1 NAT ServicesRIP 2 RIPPage Select a metric value for the interface Select a Send Mode and a Receive ModeFirewall Page IP Filter Page Bridge Filter 6 DNS Blocked Protocols Page Ddns Sntp UPnPUser Configuration AdminCommit & Reboot Committing Changes Local Image UpgradePage Remote Image Upgrade Alarm Image Upgrade SuccessfulDiagnostics Click Submit System Log Port SettingsBackup/Restore Configuration Page Management Control Configuring Autodetect Configuring the ATM Virtual Circuit Autodetect ModesAutodetect Snmp Configuration Viewing Global Snmp Statistics Creating CommunitiesClick Add Comm Viewing HostsParental Control 103