Paxar Monarch 932TM manual Tag Stop Transport Lock

Page 10

5.Move tag stop up and down by using your thumb to pull out slightly on the release tab and lift up until it stops.

Adjust the tag stop to the length of the tags.

Tag Stop

Transport Lock

6.Make sure the transport lock handle is in the locked position.

7.Make sure supply is loaded and the printer is turned on.

8.Press the Feed or Cut button on the printer or keyboard several times.

The supply should feed through the knife and tags should be cut and placed in the stacker tray.

1-6Getting Started

Image 10

Contents OperatingOperating InstructionsInstructions Canadian D.O.C. Warning TA B L E O F C O N T E N T S Ii Table of Contents T T I N G S TA R T E D Install i n g t h e S t a c k e rP a c k i n g t h e S t a c k e r E p 1 Installation f o r t h e 9 8 6 0 P r i n t e r E p 2 L e v e l t h e S t a c k e r If the stacker isE p 3 C o n n e c t t h e P o w e r C o r d E p 4 C h e c k t h e a l i g n m e n t Tag Stop Transport Lock E p 5 S e t t h e Ta g W i d t h E p 6 S e t t h e B e l t S p e e d Turn the belt adjustment knob to the number from the stack 10Getting Started W T O O P E R AT E P t y i n g t h e S t a c k e r L o a d i n g o r C h a n g i n g S u p p l i e sA c k e r F u l l E a r i n g a Ta g J a m A c k e r R u n n i n gInstall i n g R i s e r B l o c k s Troubleshooting Problem Action2Troubleshooting E C I F I C AT I O N S A c k e rP p l i e s N i m u m S t a c k e d Ta g D i m e n s i o n s