Paxar Monarch 932TM manual Troubleshooting, Problem Action

T R O U B L E S H O O T I N G			3
Problem	Action
Stacker Full or	1.	Empty the stacker tray.
760 Warning Status	2.	Place the tag weight against the tag stop.
Code	3.	Press the Escape button to clear the status code.
	4.	Continue printing.
	The stacker may not be plugged into an outlet. Verify the
	power connection.
Stacker Jam or	See Chapter 2, "Clearing a Jam" for more information.
761 Status Code	If the jam is not inside the stacker, check inside the knife or
	printer.
Stacker does not	Make sure the stacker is turned on and is properly
work.	connected to the printer. See Chaper 1, "Getting Started"
	for more information.
Tags are stacked	Empty the stacker tray. Turn the adjustment knob to a lower
too loosely.	setting.
	Adjust the guide rails and tag stop to the width and length of
	the tags.
Tags are stacked	Empty the stacker tray. Turn the adjustment knob to a
too tightly.	higher setting.
Tags are not	Adjust the guide rails and tag stop to the width and length of
stacking level or	the tags.
even.
Tags rub against the	The guide rails are too close to the tag. Adjust the guide
side guide rails.	rails.
Tags have nicked	Adjust the guide rails to the width of the tags. See Chapter
corners.	1, step 4 for more information.
The guide rails will	Make sure the guide rails are in the grooves at the bottom
not stay in place.	of the tray. See Chaper 1 for more information.

Call Service and Support for more information.

Troubleshooting 3-1