Paxar Monarch 932TM manual T T I N G S Ta R T E D, P a c k i n g t h e S t a c k e r

Page 5

G E T T I N G S TA R T E D

1

The Monarch® 932™ stacker works with a Monarch® 9860™ printer. The stacker supports backfeed mode on the printer. There is no power ON/OFF switch for the stacker. Once the stacker is plugged into an outlet, it is on.

U n p a c k i n g t h e S t a c k e r

uImportant: After unpacking the stacker, look through all packaging material for parts. Keep all packaging material for future shipping.

I n s t a l l i n g t h e S t a c k e r

Use these instructions when you first install the stacker or when you need to move the stacker to a different location.

Before installing:

uFind a level work surface at least 52" x 22" (1321 mm x 559 mm).

The 9860 printer comes with a knife attached.

uTurn off the printer before you install the stacker.

Getting Started 1-1

Page 4 Page 6
Image 5
Page 4 Page 6
Contents OperatingOperating InstructionsInstructions Canadian D.O.C. Warning TA B L E O F C O N T E N T S Ii Table of Contents P a c k i n g t h e S t a c k e r Install i n g t h e S t a c k e rT T I N G S TA R T E D E p 1 Installation f o r t h e 9 8 6 0 P r i n t e r If the stacker is E p 2 L e v e l t h e S t a c k e rE p 3 C o n n e c t t h e P o w e r C o r d E p 4 C h e c k t h e a l i g n m e n t Tag Stop Transport Lock E p 5 S e t t h e Ta g W i d t h E p 6 S e t t h e B e l t S p e e d Turn the belt adjustment knob to the number from the stack 10Getting Started W T O O P E R AT E A c k e r F u l l L o a d i n g o r C h a n g i n g S u p p l i e sP t y i n g t h e S t a c k e r A c k e r R u n n i n g E a r i n g a Ta g J a mInstall i n g R i s e r B l o c k s Problem Action Troubleshooting2Troubleshooting A c k e r E C I F I C AT I O N SN i m u m S t a c k e d Ta g D i m e n s i o n s P p l i e s
Top Page Image Contents