Paxar Monarch 932TM manual E p 2 L e v e l t h e S t a c k e r, If the stacker is

Page 7

S t e p 2 - L e v e l t h e S t a c k e r

1.Check the distance between the rollers and the knife. Make sure the rollers are not touching the front of the knife or too far from the knife. If incorrect, follow the steps below. If correct, skip this step and move on to Step 3 - Connect the Power Cord.

Rollers

Knife

The ideal position for the stacker is with the

end of tray slightly down.

2.Loosen the locking nuts with a wrench.

3.Make sure the stacker’s feet are flat on a level surface.

You can raise or lower the feet by turning them.

4. Evenly adjust both feet.

If the stacker is

Locking

Nuts

utouching the knife case, lower the feet.

utoo far from the knife, raise the feet.

5.Tighten the locking nuts.

Getting Started 1-3

Page 6 Page 8
Image 7
Page 6 Page 8
Contents OperatingOperating InstructionsInstructions Canadian D.O.C. Warning TA B L E O F C O N T E N T S Ii Table of Contents T T I N G S TA R T E D Install i n g t h e S t a c k e rP a c k i n g t h e S t a c k e r E p 1 Installation f o r t h e 9 8 6 0 P r i n t e r If the stacker is E p 2 L e v e l t h e S t a c k e rE p 3 C o n n e c t t h e P o w e r C o r d E p 4 C h e c k t h e a l i g n m e n t Tag Stop Transport Lock E p 5 S e t t h e Ta g W i d t h E p 6 S e t t h e B e l t S p e e d Turn the belt adjustment knob to the number from the stack 10Getting Started W T O O P E R AT E P t y i n g t h e S t a c k e r L o a d i n g o r C h a n g i n g S u p p l i e sA c k e r F u l l A c k e r R u n n i n g E a r i n g a Ta g J a mInstall i n g R i s e r B l o c k s Problem Action Troubleshooting2Troubleshooting A c k e r E C I F I C AT I O N SN i m u m S t a c k e d Ta g D i m e n s i o n s P p l i e s
Top Page Image Contents