Paxar Monarch 932TM manual E p 4 C h e c k t h e a l i g n m e n t

Page 9

S t e p 4 - C h e c k t h e A l i g n m e n t

1.Load supply in the printer. For more information about loading supply, refer to the printer’s Operator’s Handbook or Quick Reference.

2.Set aside the tag weight.

3.Widen the guide rails to maximum width by pulling and extending the guide rails out of the grooves at the bottom of the tray.

Guide Rails

Grooves

4.Slide the rod ends of guide rails by using both hands to the outer position.

Getting Started 1-5

Image 9

Contents OperatingOperating InstructionsInstructions Canadian D.O.C. Warning TA B L E O F C O N T E N T S Ii Table of Contents Install i n g t h e S t a c k e r T T I N G S TA R T E DP a c k i n g t h e S t a c k e r E p 1 Installation f o r t h e 9 8 6 0 P r i n t e r If the stacker is E p 2 L e v e l t h e S t a c k e rE p 3 C o n n e c t t h e P o w e r C o r d E p 4 C h e c k t h e a l i g n m e n t Tag Stop Transport Lock E p 5 S e t t h e Ta g W i d t h E p 6 S e t t h e B e l t S p e e d Turn the belt adjustment knob to the number from the stack 10Getting Started W T O O P E R AT E L o a d i n g o r C h a n g i n g S u p p l i e s P t y i n g t h e S t a c k e rA c k e r F u l l A c k e r R u n n i n g E a r i n g a Ta g J a mInstall i n g R i s e r B l o c k s Problem Action Troubleshooting2Troubleshooting A c k e r E C I F I C AT I O N SN i m u m S t a c k e d Ta g D i m e n s i o n s P p l i e s