Paxar Monarch 932TM manual E p 1 Installation f o r t h e 9 8 6 0 P r i n t e r

Page 6

S t e p 1 - I n s t a l l a t i o n f o r t h e 9 8 6 0 P r i n t e r

1.Locate the screw hole on the stacker mounting plate.

Flanged screw
Adjusting	Stacker
Adjusting	Mounting
Bracket	Plate

2.Attach the adjusting bracket to the stacker mounting plate using a flanged screw as shown (do not tighten all the way).

Guide Tab

Knife Opening

Mounting

Plate

Slot

Locating Pin	Adjusting Bracket
	Locating Hole

3.Gently lift stacker and center the guide tabs in the knife opening.

4.Set the stacker locating pins (on bottom of stacker) firmly in the adjusting bracket locating hole and mounting plate slot.

5.Tighten the adjusting bracket flanged screw.

6.Connect the stacker cable to the knife.

1-2Getting Started

Image 6

Contents OperatingOperating InstructionsInstructions Canadian D.O.C. Warning TA B L E O F C O N T E N T S Ii Table of Contents Install i n g t h e S t a c k e r T T I N G S TA R T E DP a c k i n g t h e S t a c k e r E p 1 Installation f o r t h e 9 8 6 0 P r i n t e r E p 2 L e v e l t h e S t a c k e r If the stacker isE p 3 C o n n e c t t h e P o w e r C o r d E p 4 C h e c k t h e a l i g n m e n t Tag Stop Transport Lock E p 5 S e t t h e Ta g W i d t h E p 6 S e t t h e B e l t S p e e d Turn the belt adjustment knob to the number from the stack 10Getting Started W T O O P E R AT E L o a d i n g o r C h a n g i n g S u p p l i e s P t y i n g t h e S t a c k e rA c k e r F u l l E a r i n g a Ta g J a m A c k e r R u n n i n gInstall i n g R i s e r B l o c k s Troubleshooting Problem Action2Troubleshooting E C I F I C AT I O N S A c k e rP p l i e s N i m u m S t a c k e d Ta g D i m e n s i o n s