Paxar Monarch 932TM manual Install i n g R i s e r B l o c k s

Page 18

3.Use the tab to lift the transport. Check for tags.

4.Remove the tags.

5.Lower the transport.

6.Replace the transport lock handle. Make sure it is completely in the hole at the back of the stacker. Turn the handle down to lock.

7.Press the Escape button to clear the status code.

8.Continue printing.

I n s t a l l i n g R i s e r B l o c k s

Install riser blocks as shown when using a printer and stacker with a verifier. Make sure stacker feet seat securely in the riser blocks.

Front of stacker, hole side goes up

Rear of stacker, slotted side goes up

2-4How to Operate

Image 18

Contents OperatingOperating InstructionsInstructions Canadian D.O.C. Warning TA B L E O F C O N T E N T S Ii Table of Contents Install i n g t h e S t a c k e r T T I N G S TA R T E DP a c k i n g t h e S t a c k e r E p 1 Installation f o r t h e 9 8 6 0 P r i n t e r E p 2 L e v e l t h e S t a c k e r If the stacker isE p 3 C o n n e c t t h e P o w e r C o r d E p 4 C h e c k t h e a l i g n m e n t Tag Stop Transport Lock E p 5 S e t t h e Ta g W i d t h E p 6 S e t t h e B e l t S p e e d Turn the belt adjustment knob to the number from the stack 10Getting Started W T O O P E R AT E L o a d i n g o r C h a n g i n g S u p p l i e s P t y i n g t h e S t a c k e rA c k e r F u l l E a r i n g a Ta g J a m A c k e r R u n n i n gInstall i n g R i s e r B l o c k s Troubleshooting Problem Action2Troubleshooting E C I F I C AT I O N S A c k e rP p l i e s N i m u m S t a c k e d Ta g D i m e n s i o n s