9476 Assembly and Setup Instructions
9.Slide the metal rod through the slot in the side of the drop shelf and into the hole in the Station’s corner support. Push the rod until it exits through the hole in the other corner support. You may have to reach under the support brace to guide the rod into the opposite hole. (Figure 7.)
10.Slide a plastic washer onto the exposed end of the metal rod. (Figure 7.)
11.You might need another person’s help with this step. Hold the head or side of a hammer firmly against the end of the rod with the end cap. While maintaining pressure, use a second hammer to hammer an end cap onto the exposed end of the rod. The end cap should lock firmly. (Figure 7.)
12.To collapse the shelf, lift the shelf from the sides and allow it to swing down. (Figure 8.)
Figure 8
To extend the shelf, lift the shelf until the rear lip slides down onto the top of the support brace and locks in place.