Paxar Monarch 9476 manual Attaching the Wheels and Casters, Tools You Need

Page 9

Chapter 1. Assembling the Station

Tools You Need--------------------------------------------------------------------------------------------

To assemble the Station, you need:

Fflathead (common) screwdriver

FPhillips screwdriver

Fwrenches: 7/16", 11/32", 1/4" and adjustable

Frubber mallet

Fslip-joint pliers

Fneedle-nose pliers

Fhammer

Step 1: Attaching the Wheels and Casters --------------------------------------------

1.Remove the following items from their packaging: F (2) 8" wheels

F (2) 4" casters with brakes F (2) axle mounts

F (2) axle end caps F (2) large washers F (1) axle

w

To avoid hitting your fingers, use needle-nose pliers to hold the end cap as you are hammering it onto the axle.

2.You may need an assistant for this step. Remove the collapsed Station assembly from the carton. Hold the top piece of packaging against the top of the Station and turn the Station upside down on a firm surface. The top packaging serves as a pad to protect the printer power packs, which are attached to the top of the Station.

cMake sure the printer power packs attached to the top of the Station are not crushed during the next three steps.

1-3

Image 9

Contents Assembly and Setup Instructions Canadian D.O.C. Warning Audience PrefaceSee Other DocumentationTable of Contents Troubleshooting Assembling the Station Parts ListBattery and Charger Packaging Tools You Need Attaching the Wheels and CastersWasher Axle Mount Washer end cap Wheel Axle Caster Mount Socket Adjusting the Station’s Height Attaching the Cabinet Handle and Cord Bracket Attaching Optional Items Attach the Push Handle Attach the Drop Shelf End cap Drop Shelf Support Brace Metal Rod Assembly and Setup Instructions Attach the Data Entry Terminal Cradle Install the Battery Installing the Battery and ChargerRetainer Rod Negative Rubber Bracket Retainer Rod Ground Wire Install the Battery Charger Retainer Rod Voltage Selector Battery Socket Cable Power Cord Rubber Bracket Retainer Rod External Power Socket Attach the Printer Brackets Installing the PrintersAttach the Printers Shoulder Screw Shoulder Screw Printer Bracket Fan-fold Metal Slot Printer Port Cable Chapter Loading Supplies Pull the supply guide forward and down as shown. Figure Loading Fan-Fold Supplies Supply Deflector Ring Supply Strip Fan-Fold Slot Magnetic Supply Bracket Centering Supply Deflector Supply Guide Upper Opening Loading Roll Supplies in Fan-Fold Printers Supply Holder Arrow Width Tabs NMake sure the supplies turn freely in the supply well Supply Guide Upper Opening Supply Guide Upper Opening Lower Loading Ribbon Reloading a Ribbon Cassette Assembly and Setup Instructions Printing Assembly and Setup Instructions Charging the Battery Important Charging Information Battery Life Assembly and Setup Instructions Solving Problems Chapter TroubleshootingChanging Fuses Changing the Battery FuseTroubleshooting Changing the AC Fuse Troubleshooting Assembly and Setup Instructions Utility Cart BatteryOutput ChargerPage Toll Free