Paxar Monarch 9476 manual Assembly and Setup Instructions

Page 48

9476 Assembly and Setup Instructions

4.Remove the used ribbon and take-up reel and discard. Open a package of new ribbon.

nDo Not wrinkle or crush the ribbon.

5.With the ridged end of the take-up reel facing down, place the ribbon roll on the spool with the foam washer (on the half of the cassette with the latches). Do not push the ribbon roll down onto the spool yet.

6.Feed the ribbon around the guides and place the take-up reel onto the shorter spool.

7.Twist the ribbon roll back and forth as you firmly push it down until it is seated on the spool.

nF Do Not force the ribbon roll down onto the spool; you could damage the foam washer.

FMake sure the preprinted side of the ribbon faces out.

FMake sure the latches are still in the unlocked position

( ) before fitting the two halves of the cassette together.

FIf you are using a 2-inch or 3-inch-wide ribbon, push the core of the ribbon roll to seat the ribbon roll onto the cassette’s spool. Do not touch the ribbon because it may wrinkle and twist.

8.Replace the other half of the cassette. The two halves should fit together completely. Rotate the latches until

they click into the closed position ( ).

9.Check to make sure that the ribbon is loaded correctly; the ribbon should be wound tightly inside the cassette. Turn the gear counterclockwise with your fingers until the black portion of the ribbon is exposed.

10.If the ribbon does not advance, or if it is hard to turn the gear, repeat the loading procedure.

2-16

Image 48
Contents Assembly and Setup Instructions Canadian D.O.C. Warning Preface AudienceOther Documentation SeeTable of Contents Troubleshooting Parts List Assembling the StationBattery and Charger Packaging Attaching the Wheels and Casters Tools You NeedWasher Axle Mount Washer end cap Wheel Axle Caster Mount Socket Adjusting the Station’s Height Attaching the Cabinet Handle and Cord Bracket Attaching Optional Items Attach the Push Handle Attach the Drop Shelf End cap Drop Shelf Support Brace Metal Rod Assembly and Setup Instructions Attach the Data Entry Terminal Cradle Installing the Battery and Charger Install the BatteryRetainer Rod Negative Rubber Bracket Retainer Rod Ground Wire Install the Battery Charger Retainer Rod Voltage Selector Battery Socket Cable Power Cord Rubber Bracket Retainer Rod External Power Socket Installing the Printers Attach the Printer BracketsAttach the Printers Shoulder Screw Shoulder Screw Printer Bracket Fan-fold Metal Slot Printer Port Cable Chapter Loading Supplies Pull the supply guide forward and down as shown. Figure Loading Fan-Fold Supplies Supply Deflector Ring Supply Strip Fan-Fold Slot Magnetic Supply Bracket Centering Supply Deflector Supply Guide Upper Opening Loading Roll Supplies in Fan-Fold Printers Supply Holder Arrow Width Tabs NMake sure the supplies turn freely in the supply well Supply Guide Upper Opening Supply Guide Upper Opening Lower Loading Ribbon Reloading a Ribbon Cassette Assembly and Setup Instructions Printing Assembly and Setup Instructions Charging the Battery Important Charging Information Battery Life Assembly and Setup Instructions Chapter Troubleshooting Solving ProblemsChanging the Battery Fuse Changing FusesTroubleshooting Changing the AC Fuse Troubleshooting Assembly and Setup Instructions Battery Utility CartCharger OutputPage Toll Free