Paxar Monarch 9476 manual Important Charging Information

Page 52

9476 Assembly and Setup Instructions

Important Charging Information ----------------------------------------------------------

w

DANGER! RISK OF ELECTRICAL AND FIRE HAZARD.

CERTAIN ACTIONS MAY RESULT IN DEATH, SERIOUS

INJURY, SHOCK, OR BURNS.

FDo Not disassemble the battery charger; take it to an authorized repair center for repair or service.

FDo Not operate the Station while the battery charger is charging.

FDo Not expose the battery charger to rain or snow. Never charge a frozen battery.

FPlug only into a grounded outlet with three holes. Do Not alter the AC power cord or plug provided. Do Not operate the battery charger with a damaged cord or plug.

FDo Not let the battery remain fully or partly discharged for a long time; keep it charged.

FIf using an extension cord, you must use #18 or heavier for lengths up to 50 feet, or #16 or heavier for lengths up to 100 feet. Use of improper extension cord could cause fire and electric shock.

FPull on the plug rather than the cord when disconnecting the battery charger. Locate the cords where they will not be stepped on, tripped over, or otherwise subjected to damage or stress.

FThe battery must be charged when the voltage is 10.5V or less. Print a test label to determine the voltage. The charger will not charge if the voltage is less than 3 volts. Call Technical Support for information about charging a "deeply discharged" battery.

3-2

Image 52
Contents Assembly and Setup Instructions Canadian D.O.C. Warning Preface AudienceOther Documentation SeeTable of Contents Troubleshooting Parts List Assembling the StationBattery and Charger Packaging Attaching the Wheels and Casters Tools You NeedWasher Axle Mount Washer end cap Wheel Axle Caster Mount Socket Adjusting the Station’s Height Attaching the Cabinet Handle and Cord Bracket Attaching Optional Items Attach the Push Handle Attach the Drop Shelf End cap Drop Shelf Support Brace Metal Rod Assembly and Setup Instructions Attach the Data Entry Terminal Cradle Installing the Battery and Charger Install the BatteryRetainer Rod Negative Rubber Bracket Retainer Rod Ground Wire Install the Battery Charger Retainer Rod Voltage Selector Battery Socket Cable Power Cord Rubber Bracket Retainer Rod External Power Socket Installing the Printers Attach the Printer BracketsAttach the Printers Shoulder Screw Shoulder Screw Printer Bracket Fan-fold Metal Slot Printer Port Cable Chapter Loading Supplies Pull the supply guide forward and down as shown. Figure Loading Fan-Fold Supplies Supply Deflector Ring Supply Strip Fan-Fold Slot Magnetic Supply Bracket Centering Supply Deflector Supply Guide Upper Opening Loading Roll Supplies in Fan-Fold Printers Supply Holder Arrow Width Tabs NMake sure the supplies turn freely in the supply well Supply Guide Upper Opening Supply Guide Upper Opening Lower Loading Ribbon Reloading a Ribbon Cassette Assembly and Setup Instructions Printing Assembly and Setup Instructions Charging the Battery Important Charging Information Battery Life Assembly and Setup Instructions Chapter Troubleshooting Solving ProblemsChanging the Battery Fuse Changing FusesTroubleshooting Changing the AC Fuse Troubleshooting Assembly and Setup Instructions Battery Utility CartCharger OutputPage Toll Free