RuggedCom RS969 manual Fast Ethernet Ports Signal Description, Pin Signal

2.7 Fast Ethernet Ports – Signal Description

The RS969 series switches have several 10/100BaseTX ports that allow connection to standard CAT-5 UTP cable with industrial RJ45 male connectors or industrial D-coded M12 male connectors. The RJ45/M12 receptacles are directly connected to the chassis ground on the M969 and can accept shielded CAT-5 cables. If shielded cables are used, care must be taken to ensure the shielded cables do not form a ground loop via the shield wire and the RJ45/M12 receptacles at either end. Figure 2.6.1 shows the pin configuration.

Pin	Signal
1	+Rx
2	-Rx
3	+Tx

4No Connection

5No Connection

6-Tx

7No Connection

8No Connection

Case Shield (Chassis Ground)

Figure 2.6.1 RJ45 Port and M12 Port Pins

NOTE: RuggedCom does not recommend the use of CAT-5 cabling of any length for critical real- time substation automation applications. However, transient suppression circuitry is present on all copper ports to protect against damage from electrical transients and to ensure IEC 61850-3 and IEEE 1613 Class 1 conformance. This means that during the transient event communications errors or interruptions may occur but recovery is automatic.

RuggedCom also does not recommended to use these ports to interface to field devices across distances which could produce high levels of ground potential rise, (i.e. greater than 2500V) during line to ground fault conditions.

	19
 2008 RuggedCom Inc. All rights reserved	Rev104