3Com NJ220 manual Installing

		Installing the IntelliJack		5
	Component	Purpose	3C Number(s)
	Local power	For locally powering a single IntelliJack;	3CNJPSL
	supply	required if your network does not support
		Power Over Ethernet.
	VoIP telephone	For powering a VoIP telephone on a network	3CNJVOIPMOD-NBX
	power cable	that uses Capacitive Power Discovery	3CNJVOIPMOD-20
		Process-compatible Power Over Ethernet.
			3CNJVOIP-CPOD
			3CNJVOIP-CPOD-20
	Extension ring	For ensuring that the IntelliJack is properly	3CNJEXTRING
		mounted to a cubicle; required if the cubicle
		opening:
		n Has a depth of fewer than 1.5 inches.
		n Does not support the NEMA-WD6
		standard.
		n Does not have pre-drilled screw holes for
		standard mounting.
Installing the
	Installing the IntelliJack consists of the following steps:
IntelliJack

1Set up the power supply (page 6).

2Install the adapter plate and pass-through ports (page 8).

3Plan the installation (page 9).

4Set up the network cabling at your site (page 10).

5Connect the IntelliJack to the network (page 10).

6Mount the IntelliJack to the wall or office cubicle (page 11).

7Connect the local power supply (page 12; optional) not required if your network supports Power Over Ethernet or if you are using a single-port or multi-port power supply).

8Connect network devices to the IntelliJack (page 13).