3Com 10014917 manual Radius Scheme view, Ethernet Port view Web command Device ACL/QoS QoS

3Com Switch 4200G Family	41
Command Reference

timer

Use the timer command to set the interval to send handshake packets.

Cluster view

timer

Use the timer command to set the response timeout time of RADIUS server (that is, the timeout time of the response timeout timer of RADIUS server).

RADIUS Scheme view

timer quiet

Use the timer quiet command to set the wait time for the primary server to restore the active state.

RADIUS Scheme view

timer realtime-accounting

Use the timer realtime-accountingcommand to set the real-time accounting interval.

RADIUS Scheme view

timer response-timeout

Use the timer response-timeoutcommand to set the response timeout time of RADIUS servers.

RADIUS Scheme view

topology accept

Use the topology accept command to confirm the current topology information of the cluster and save that as a standard topology.

Cluster view

topology restore-from

Use the topology restore-fromcommand to obtain and restore the standard topology information from the local flash.

Cluster view

topology save-to

Use the topology save-tocommand to save the standard topology information into the local flash.

Cluster view

tracemac

Use the tracemac command to locate a device by MAC address or IP address.

Any view

tracert

Use the tracert command to trace the gateways the test packets passes through during its journey from the source to the destination.

Any view

The tracert command is primarily used to check the network connectivity. It can also help you locate the trouble spot of the network.

traffic-limit

Use the traffic-limitcommand to use ACL rules in traffic identifying and traffic policing for the packet matching with the ACL rules and to set traffic policing parameters and different actions for packets within the traffic limit and packets beyond the traffic limit.

Ethernet Port view

Web command: Device -> ACL/QoS -> QoS

traffic-priority

Use the traffic-prioritycommand to use ACL rules in traffic identifying and specify a new priority for the packet matching with the ACL rules.

Ethernet Port view

traffic-redirect

Use the traffic-redirectcommand to use ACL rules in traffic identifying and redirect the packets matching with the ACL rules to the specified port.

Ethernet Port view

traffic-remark-vlanid

Use the traffic-remark-vlanidcommand to use ACL rules in traffic identifying and perform the VLAN tag remark operation on the packets matching with the ACL rules.

Ethernet Port view

traffic shape

Use the traffic-shapecommand to enable traffic shaping and send the packets out at an even rate.

Ethernet Port view