Rosewill RGS-1024 Installation, Mounting the Switch on a Desk, Mounting the Switch in a Rack

Page 10

24-Port Gigabit Ethernet Switch RGS-1024

User Manual

 

 

 

Chapter 2. Installation

2.1 Mounting the Switch on a Desk

Before place the Switch on a desk, attach four rubber footpads to the flutes on the Switch bottom, then lay the Switch on the desktop, where can be have as much as 5kg placed on top.

Note:

1.The electrical outlet shall be installed near the device and shall be easily accessible.

2.Make sure there is free space for radiating heat and air.

3.Make sure not to place anything too heavy on top of the switch.

2.2 Mounting the Switch in a Rack

The dimension of RGS-1024 is designed according to the standard 19 rack-mountable steel case of Electronic Industries Association.

Turn off all the equipment connected to the Switch before mounting it in the rack, then rivet the two "L" brackets onto each side of the Switch, fasten it with screws in the rack.

Figure 2-1 Rivet the “L” brackets onto the Switch

-9-

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Port Gigabit Ethernet Switch RGS-1024 Copyright & Trademarks FCC Statement Safety Warning CE Mark WarningPort Gigabit Ethernet Switch RGS-1024 Package Contents Introduction of the Product Overview of the ProductFeatures Ieee 802.1p QoSPort Gigabit Ethernet Switch RGS-1024 Mounting the Switch on a Desk InstallationMounting the Switch in a Rack Power On Fasten the Switch in the rackFront Panel LED IndicatorsIdentifying External Components Rear PanelPort Gigabit Ethernet Switch RGS-1024 Appendix a Specifications GeneralEnvironmental and Physical Appendix B Troubleshooting Power LED is not lit
Top Page Image Contents