Rosewill RGS-1024 user manual Appendix B Troubleshooting, Power LED is not lit

Page 16

24-Port Gigabit Ethernet Switch RGS-1024

User Manual

 

 

 

Appendix B: Troubleshooting

1. The Power LED is not lit

¾Make sure the AC power cord connected the Switch with power source properly.

¾Make sure the power source is ON.

2.The Link/Act LED is not lit when a device is connected to the corresponding port

¾Make sure that the cable connectors are firmly plugged into the Switch and the device.

¾Make sure the connected device is turned on and working well.

¾The cable must be less than 100 meters long (328 feet).

Thank you for purchasing a quality Rosewill Product.

Please register your product at: www.rosewill.com for complete warranty information and future support for your product.

Rosewill Customer Service Hotline: 1-800-575-9885

Rosewill Customer Service Support:

techsupport@rosewill.com

7109504170

-15-

Page 15 Page 16
Image 16
Page 15 Page 16
Contents Port Gigabit Ethernet Switch RGS-1024 Copyright & Trademarks FCC Statement Safety Warning CE Mark WarningPort Gigabit Ethernet Switch RGS-1024 Package Contents Introduction of the Product Overview of the ProductFeatures Ieee 802.1p QoSPort Gigabit Ethernet Switch RGS-1024 Mounting the Switch on a Desk InstallationMounting the Switch in a Rack Power On Fasten the Switch in the rackLED Indicators Identifying External ComponentsFront Panel Rear PanelPort Gigabit Ethernet Switch RGS-1024 Appendix a Specifications GeneralEnvironmental and Physical Appendix B Troubleshooting Power LED is not lit
Top Page Image Contents