INSTALLATION
Switch installation – Single unit
PLEASE REFER TO THE SAFETY SECTION
BEFORE INSTALLATION
The basic installation of a single UltraMatrix switch is an easy and straightforward procedure. To install a single switch, perform the below steps for all computers/servers that will be connected. It is recommended that all computers and servers be powered off. When a computer is connected and then booted, the UltraMatrix will automatically determine the keyboard and mouse types used for that computer and no pre-configuration of the CPU port is needed. If removing power from a computer or server is not practical, pre-configure the UltraMatrix’s CPU port to define that CPU port’s keyboard and mouse types. The default keyboard type is PC mode 2 and the mouse type is PS/2. If the computer being connected uses a PC2 keyboard and PS/2 mouse, no pre-configuration of the CPU port is needed. If not, pre-configure the CPU port (Steps 5a-f) for the keyboard and mouse types for that CPU before connecting the computer. This procedure should only be done if the CPUs keyboard and mouse can be disconnected and re-connected with power applied to the computer without affecting the interface.
CPU’s 1-16
KVM’s 1-4
Figure 4. Installation - Single unit
ULTRAMATRIX “UMX” SERIES INSTALLATION AND OPERATIONS MANUAL