PowerDsine PD-6006 manual 10/100BASE-TX Ports Definition, Indicators, Data Input Ports

PD-6006/12/24

2.210/100BASE-TX Ports Definition

2.2.1Data Input Ports

According to the model acquired, the Midspan has 6, 12 or 24 10Base- T/100Base-TX- data input ports, configured in a non-crossover manner

(straight-wired). These ports, shown in Figure 2-1 (bottom row of connectors), are designed to carry Ethernet data only (Tx/Rx) over the standard 2-wire pairs (pins 1/2 and 3/6).

2.2.2Data & Power Output Ports

The Midspan has 6, 12 or 24 Data & Power ports also configured in non- crossover manner (straight-wired). These ports are designed to carry Ethernet data over the standard 2-wire pairs (pins 1/2 and 3/6) and DC power over the spare pairs (pins 4/5 and 7/8).

The Power over LAN Midspan is not a repeater. As such, the maximum distance from the

Ethernet switch is not to exceed 100 meters (328 ft). In accordance with the IEEE 802.3

standard, the Power over LAN Midspan is guaranteed to work up to this distance.

Figure 2-1: Power over LAN Midspan, Front View (PD-6024)

2.3Indicators

A set of indicators provide the status of the Power over LAN Midspan and its ports. Refer to Table 2-1 and Table 2-2 for status information during operation.

2.3.1Primary Power Indicators

Depending on the configuration ordered, there may be two LEDs on the front panel, marked by “AC” and “DC”, to provide the Power over LAN Midspan power status. When either one of the indicators is illuminated in green, the Power over LAN Midspan is receiving AC or DC power. The “AC” and “DC”

indicators are lit in orange to indicate an internal fault. Refer to Table 2-1 for additional information.

Power over LAN Solutions 8 Cat. No.: 06-6800-056