Panduit PN380 manual Connecting to a DPoE Power Patch Panel

Page 11

PANDUIT DPoE Power System User’s Guide

 

Issue 1.0

 

 

 

Part Number: PN380

 

 

 

 

 

 

Power Connector on

 

 

rear side of DPoE

 

 

Power Patch Panel

 

 

 

 

 

 

 

 

 

Butt splices connectors

 

 

 

 

 

 

48VDC Supply

Connector pinouts

Power connector housing with wire leads

Figure 3: Connecting to a DPoE Power Patch Panel

NOTE:

The included power harness has two wires for the A-feed power only (pins 1 & 2). The DPoE Power Patch Panel supports an optional redundant B- feed power option, but the terminals and wire leads are not attached to the power harness.

Contact PANDUIT Technical Support for more information about connecting the redundant B-Feed power.

WARNING:

The power supply connections on the DPoE Power Patch Panel are polarized.

The DPoE Power Panel will not function if power is wired improperly.

6

Page 10 Page 12
Image 11
Page 10 Page 12
Contents February DPoE Power System User’s Guide IssueFCC Compliance Statement Safety WarningsWarranty Information Trademarks Table of Contents Heat Dissipation Overview General Practices DPoE Power Components Available from Panduit Corporation Heat Dissipation Package Contents AC Input Wiring Recommended AC Circuit Breaker and Wire Sizes DC Output Wiring SizingDC Wire Diagram Connecting to a DPoE Power Patch Panel Site and Equipment Preparation Torque SettingsRequired Tools Panduit Corporation Contact Information Power Plant Mounting and WiringMechanical Mounting AC InputCord Bracket Chassis Front View GMT fuse holder DC OutputRectifiers Power UpTest and Turn-Up Ethernet ConnectionsNIC Information TroubleshootingTroubleshooting Short Circuit and Current LimitNIC Default Settings NIC Card SettingsBDT Time MNT
Top Page Image Contents