Panduit PN380 manual Safety Warnings, Warranty Information, FCC Compliance Statement

Page 2

PANDUIT DPoE Power System User’s Guide

Issue 1.0

 

Part Number: PN380

 

 

Safety Warnings

The DPoE Power Patch Panel Power System is for use in restricted access locations only. It is suitable for mounting on concrete or other non-combustible surfaces.

Always observe standard safety precautions during installation, operation and maintenance of this product. Read the installation instructions before performing any work. Only a competent technician who is aware of the hazards involved should carry out adjustment, maintenance or repairs. Do not work on the system or connect or disconnect cables during periods of lightning activity. Ultimate disposal of this product should be handled according to all national laws and regulations.

WARNING:

HAZARDOUS VOLTAGE AND ENERGY LEVELS ARE PRESENT THAT CAN PRODUCE SERIOUS SHOCKS AND BURNS. Only authorized, qualified, and trained personnel should attempt to work on this equipment.

CAUTION:

The plug end of the cords used to connect to the Alternating Current (AC) source are considered to be the primary disconnect means, and reasonable access must be given to the plug and receptacle area.

The receptacle must be fed with a breaker or fuse according to the instructions in this guide.

CAUTION:

ALL RECTIFIERS EMPLOY INTERNAL DOUBLE POLE/NEUTRAL FUSING

FCC Compliance Statement

This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired operation.

WARNING:

Changes or modifications to this unit not expressly approved by the party responsible for the compliance could void the user's authority to operate this equipment.

Warranty Information

Unless otherwise specified, all products presented in this user's guide are warranted against defects in material and workmanship for a period of one year from the date of invoice by PANDUIT® Corp. to the initial purchaser. During the warranty period PANDUIT Corp. will, at its discretion, either repair or replace products that prove to be defective. For warranty service or repair, the product claimed to be defective must be returned to a service facility designated by PANDUIT Corp. Buyer shall prepay all the shipping charges to PANDUIT Corp. and if, in the opinion of PANDUIT Corp., the product is defective, PANDUIT Corp. shall pay shipping charges to return the product to Buyer. However, Buyer shall pay all shipping charges, duties and taxes for products returned to PANDUIT Corp. from another country. PANDUIT Corp. warrants that its firmware designed by PANDUIT Corp. for use with an instrument will execute its functions when properly installed on that instrument. PANDUIT Corp. does not warrant that the operation of the instrument or the firmware will be uninterrupted or error-free.

i

Image 2
Contents DPoE Power System User’s Guide Issue FebruaryFCC Compliance Statement Safety WarningsWarranty Information Trademarks Table of Contents Heat Dissipation Overview DPoE Power Components Available from Panduit Corporation General PracticesHeat Dissipation Package ContentsAC Input Wiring DC Output Wiring Sizing Recommended AC Circuit Breaker and Wire SizesDC Wire Diagram Connecting to a DPoE Power Patch Panel Site and Equipment Preparation Torque SettingsRequired Tools AC Input Power Plant Mounting and WiringMechanical Mounting Panduit Corporation Contact InformationCord Bracket DC Output Chassis Front View GMT fuse holderEthernet Connections Power UpTest and Turn-Up RectifiersShort Circuit and Current Limit TroubleshootingTroubleshooting NIC InformationNIC Card Settings NIC Default SettingsBDT Time MNT