PANDUIT DPoE Power System User’s Guide | Issue 1.0 |
| Part Number: PN380 |
Table 1: DPoE Power Components Available from PANDUIT Corporation
|
|
|
| PANDUIT Part Number |
|
| Description |
|
Individual power supply |
| DPoEPWRB120 |
| Individual power supply - 120 watt power |
| |||
|
|
|
|
|
|
| supply – 48 volt output |
|
|
|
|
| DPoEPWRCM |
|
| Managed power chassis - supports 3 rectifiers |
|
|
|
|
|
|
|
| - equipped with Network Interface Card |
|
| System |
|
| DPoEPWRCU |
|
| Unmanaged power chassis - supports 3 |
|
|
|
|
|
|
| rectifiers - does not include Network Interface |
| |
|
|
|
|
|
| Card. |
| |
|
|
| DPoEPWRR500 |
|
| 500 watt rectifier for use in either |
| |
|
|
|
|
|
| DPoEPWRCM or DPoEPWRCU chassis |
| |
| Power |
|
|
|
|
|
|
|
|
|
| DPoEPWRF10 |
|
| 10 amp fuse (package of 10) |
| |
|
|
|
| DPoEPWRR1250 |
|
| 1250 watt rectifier for use in either |
|
|
|
|
|
|
|
| DPoEPWRCM or DPoEPWRCU chassis |
|
| DPoE |
|
|
|
|
|
|
|
|
|
| DPoEPWRNIC |
|
| Network Interface Card |
| |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| |
|
|
|
|
| Power cord for Australia |
| ||
|
|
|
|
|
|
|
| |
|
|
|
|
| Power cord for Europe |
| ||
|
|
|
|
| Power cord for USA |
| ||
|
|
|
|
| Power cord for the U.K. |
| ||
|
|
|
|
|
|
|
|
|
INSTALLATION
General Practices
Observe all local and national electrical, environmental, and workplace codes.
Each chassis should be fed from a dedicated AC branch circuit of a TN or IT power system.
CAUTION:
The plug ends on the power cords used for the AC connections are considered to be the primary disconnect means. Reasonable access must be given to the plug and receptacle area. The receptacle must be fed with a breaker or fuse according to Table 4: Recommended AC Circuit Breaker and Wire Sizes.
Use single hole, Underwriters Laboratory (U.L.) listed lugs for the bulk DC connection to prevent lug rotation and inadvertent contact with other circuits. Terminal strip connections use compression screws.
Class 1 wire is recommended for all DC connections.
Minimum wire sizes for protected and unprotected circuits are shown in Table 5: Minimum Recommended DC AWG for 90° C Cabling for Unprotected Outputs , respectively. In practice, loop voltage drop considerations will usually dictate larger than minimum safe wire size.
For connection and mounting torque requirements see Table 6: Recommended Torque Settings.
PANDUIT Corp. does not recommend shipping the chassis with the rectifiers installed. Rectifiers should be shipped in their separate boxes.
2