V. Accessing a VersaCam IC Series Homepage & Monitoring
After assigning the VersaCam an IP address, you can configure the VersaCam from within its own web pages by using any standard Web browser on a local or remote network.
A. Starting a Web Browser
Start your web browser by entering your VersaCam’s IP address. Then you can see the
•Example http://200.243.232.178/
VersaCam IC Series simultaneously supports up to 100 users. If a person tries to access VersaCam as the 101st user, they will not receive any image but will see a message on upper right side of the homepage: ‘Running Video Channel: 101’.
B. Login page
1) ID and password
To connect to a VersaCam, you must follow the Login procedures. If you key in a user’s ID and Password, you may access the viewer to monitor
The default user’s ID and password are set to ‘guest’, and the administrator may change them through the Admin page. Note that each ID and password may be composed of up to 9 letters.
2)Behind A Firewall
If the PC is connected to a network where a firewall is installed, the real time image may not be displayed properly because the video TCP port of VersaCam is blocked. The default video TCP port of a VersaCam (8080) is often blocked under a firewall. In this case, the real time image may be viewed by using the VersaCam’s Server Push Viewer that transmits video through a Web TCP port instead of the video TCP port.
To connect to the Server Push Viewer, click on the ‘Behind Firewall’ menu selection. Performance will likely be slower in this mode.
13 | VersaCam |