SUPER MICRO Computer AS1011M-T2 user manual Power Fail Alarm Reset Header, Compact Flash Power

AS1011M-T2 User's Manual

Power Fail Alarm Reset Header

Connect JAR to the alarm reset but- ton on your chassis (if available) or to a microswitch to allow you to turn off the alarm that sounds when a power supply module fails. See the table on the right for pin defi nitions.

Alarm Reset Header Pin Definitions (JAR)

Pin# Defi nition

1Ground

2Reset Signal

Compact Flash Power

ACompact Flash Card Power header is located at JWF1. For the Compact Flash Card to work properly, you will first need to connect the device's power cable to JWF1 and correctly set the Compact Flash Jumper (JCF1).

SGPIO

T-SGPIO1 and T-SGPIO2 (Serial General Purpose Input/Output) pro- vide a bus between the SATA control- ler and the SATA drive backplane to provide SATA enclosure management functions. Connect the appropriate cables from the backplane to the T- SGPIO1 and T-SGPIO2 header(s) to utilize SATA management functions on your system.

Compact Flash

Power Header

Pin Definitions (JWF1)

Pin# Defi nition

1+5V

2Ground

3 Signal

SGPIO Headers

Pin Definitions (T-SGPIO1, T-SGPIO2)

Pin#	Defi nition	Pin #	Defi nition
1	NC	2	NC
3	Ground		Data
		4
5	Load		Ground
		6
7	NC		NC
		8

Note: NC indicates no connection.

5-18