StorCase Technology manual DS100 Rear Panel DS100 2-Bay Shown

Page 14

Introduction

5

 

 

DS100 Rear Panel

(Figure 4)

SCSI ID Select Switch(es) - Provide SCSI ID selection. The DS100 uses one (1), two (2), or four (4) rotating switches depending on model (refer to “Selecting the SCSI ID Number” for additional information).

Fuse - A fuse located on the rear panel protects the DS100 circuitry (refer to Ap- pendix B for fuse removal and installation information).

Power Switch - Provides power to the DS100 chassis.

A/C Connector - Accepts U.S. and other available international standard power cables. Contact StorCase for further ordering information.

I/O Connector - The DS100 is available with one (1) 68-pin VHDCI (for SCSI Ultra320) connector.

NOTE: The Ultra320 DS100 does not support daisy-chaining.

SCSI I/D

 

Power

Select Switches

Fuse

Switch

S1

S2

 

 

0527C

I/O Connector

A/C

(VHDCI)

Power In

Figure 4: DS100 Rear Panel

(DS100 2-Bay Shown)

 

 

 

DS100 (U320) User's Guide - Rev. A02

StorCase Technology, Inc.

Image 14
Contents Data Silo DS100 Data Silo DS100 Part No. D89-0000-0208 A02 MayLimited Warranty Free Technical Support Declaration of Conformity CSA NRTL/C TUVFederal Communications Commission FCC Statement RadiofrequencyinterferencestatementImportant Safety Instructions Wichtige SicherheitshinweiseTable of Contents Scsi ID Selection Switches List of Figures contdPackaging Information Serial NumberGeneral Description Data Silo DS100 FamilyOn LED Front Panel DS100 Front Panel DS100 2-Bay ShownDS100 Rear Panel DS100 Rear Panel DS100 2-Bay ShownInstalling the Drives into the DS100 Removing the DS100 CoverDrive Preparation Removing the Cover Bay ShownIf Installing a 8-BIT Scsi Device RowIf Installing a 16-BIT Scsi Device Typical Drive 16-Bit Single-Ended ID Select PinsDrive Installation If Installing a Drive Into the DS100 1-BAY or DS100 2-BAYRemoving the Drive Mounting Bracket DS100 2-Bay Shown 0539 0541A If Installing a Drive Into the DS100 4-BAY Page Scsi ID Selection Switch Selecting the Scsi ID NumberConnecting the DS100 to the Computer System Host ControllerThis Page Left Blank Intentionally Appendices Appendix a Specifications/Dimensions Environmental Specifications Operating StorageAppendix a Specifications/Dimensions Appendix B Fuse Removal Figure B-1 Removing the FuseReaders Comments S I N E S S R E P LY M a I L