StorCase Technology DS100 manual Drive Installation

10 Installation

Terminator

0535A

Use Flat Blade

Screwdriver to

Remove Filler Panel

Figure 9: Removing the Filler Panel

Drive Installation

The process of installing a drive into the DS100 chassis varies slightly, depending upon the model. DS100 1-bay and 2-bay models require the removal of the drive mounting bracket to access drive mounting screws. The DS100 4-bay does not require the removal of the drive mounting bracket.

IF INSTALLING A DRIVE INTO THE DS100 1-BAY OR DS100 2-BAY:

1.Turn the DS100 over and place it on a soft clean surface, so that the bottom is facing upward.

2.Loosen but do not remove the four (4) screws that secure the drive mounting bracket to the DS100 chassis (Figure 10).

3.Place the DS100 in an upright position so that it rests on its four rubber feet.

4.Remove the drive mounting bracket from the chassis by sliding it toward the chassis back panel, then lifting upward.

StorCase Technology, Inc. DS100 (U320) User's Guide - Rev. A02