12 | Installation |
|
|
7.Install the drive(s) into the drive mounting bracket using four (4)
LEFT
SIDE
|
|
|
| S |
|
|
|
| CSI |
|
|
|
| ID |
| FA |
|
|
|
| CT |
|
|
|
W | OR |
| SIDE | |
NG | Y | NE | ||
AR |
|
| ||
| NI |
| W | RIGHT |
|
|
|
| |
3.5" Drive
(Not Included)
3.5" Drive
Adapter Brackets
Drive Fault
LED Cable
Drive Activity
LED Cable
5.25" Drive Mounting Bracket
Pan Hd. Screw (4 Plcs per Drive)
0539
Figure 12: Installing the Drive into the Drive Mounting Bracket
(DS100 2-Bay Shown)
8.After the drive(s) have been fastened into the mounting bracket, carefully insert the bracket back into the DS100 chassis (Figure 13). Be careful that no cables are pinched. Position the screws on the bottom of the mounting bracket through the slots on the bottom of the DS100 chassis so that the bracket can slide freely. Do not tighten the drive mounting bracket screws at this point.
9.Slide the drive mounting bracket as far as it will go toward the front of the DS100 chassis to allow access for attaching cables at the rear of the DS100.
10.Connect the I/O cable(s) to the drive(s). Verify that the Pin 1 indicator on the cable is properly aligned (refer to the drive manufacturer's documentation for more informa- tion).
StorCase Technology, Inc. | DS100 (U320) User's Guide - Rev. A02 |