SMC Networks SMCWBR14S-N4 manual Wizard WAN Settings Pptp

CHAPTER 4 Initial Configuration

Setup Wizard

STEP 3 - WAN

SETTINGS - PPTP

address to the Wireless Broadband Router, then click the “Clone your PC’s MAC Address” (Default: Disable)

Enables the Point-to-Point Tunneling Protocol (PPTP) for implementing virtual private networks. The service is provided in many European countries.

Figure 18: Wizard Step 3 - WAN Settings - PPTP

The following items are displayed on this page:

◆Server IP — Sets the PPTP server IP Address. (Default: pptp_server)

◆User Name — Sets the PPTP user name for the WAN port. (Default: pptp_user; Range: 1~32 characters)

◆Password — Sets a PPTP password for the WAN port. (Default: pptp_password; Range: 1~32 characters)

◆Verify Password — Prompts you to re-enter your chosen password.

◆Address Mode — Sets a PPTP network mode. (Default: Static)

◆IP Address — Sets the static IP address. (Default: 0.0.0.0, available when PPTP Network Mode is set to static IP.)

◆Subnet Mask — Sets the static IP subnet mask. (Default: 255.255.255.0, available when PPTP Network Mode is set to static IP.)

◆Default Gateway — The IP address of a router that is used when the requested destination IP address is not on the local subnet.

– 45 –