Seagate ST31000533CS manual Will display the warranty information for your drive

Page 11

Drive specification	ST31000533CS
Vibration, operating	2–22 Hz: 0.25 Gs, Limited displacement
	22–350 Hz: 0.50 Gs
	350–500 Hz:: 0.25 Gs

Vibration, nonoperating	5–22 Hz: 2.0 Gs
	22–350 Hz: 5.0 Gs
	350–500 Hz:: 2.0 Gs

Drive acoustics, sound power
Idle**	2.9 bels (typical)
	3.1 bels (max)
CE Seek Profile	3.1 bels (typical)
	3.2 bels (max)

Nonrecoverable read errors	1 per 1014 bits read
Annualized Failure Rate (AFR)	0.62%

Warranty	To determine the warranty for a specific drive, use a web browser to access the following
	web page: support.seagate.com/customer/warranty_validation.jsp
	From this page, click on the “Verify Your Warranty” link. You will be asked to provide the
	drive serial number, model number (or part number) and country of purchase. The system
	will display the warranty information for your drive

Contact start-stop cycles	50,000 at 25°C, 50% rel. humidity

Supports Hotplug operation per the	Yes
Serial ATA Revision 2.5 specification

*One Gbyte equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting.

**During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels.

Pipeline HD Pro Serial ATA Product Manual, Rev. C

5

Image 11

Contents ST31000533CS Pipeline HD Pro Serial ATARevision Date Sheets affected or comments Revision historyContents Pipeline HD Pro Serial ATA Product Manual, Rev. C List of Figures Page Introduction About the Serial ATA interface Drive specifications Drive specifications summary for 1000 Gbyte models Will display the warranty information for your drive Recording and interface technology Default logical geometryLBA mode Formatted capacityTypical seek times msec Read Write Physical characteristicsSeek time Start/stop timesPower specifications Sleep mode Power-management modesActive mode Idle modeEnvironmental specifications Nonoperating vibration Nonoperating shock GB modelsVibration Operating vibrationTest for Prominent Discrete Tones PDTs AcousticsElectromagnetic immunity Fluid Dynamic Bearing FDB motor acousticsElectromagnetic compatibility Safety certificationReliability Agency certificationFCC verification Korean RRLAustralian C-Tick N176 Corrosive environment Environmental protectionPipeline HD Pro Serial ATA Product Manual, Rev. C Handling and static-discharge precautions Configuring and mounting the driveSerial ATA cables and connectors Configuring the driveDrive mounting Mounting dimensions 1000 GB modelsPipeline HD Pro Serial ATA Product Manual, Rev. C Hot-Plug compatibility Serial ATA Sata interfacePin Function Definition Serial ATA device plug connector pin definitionsSerial ATA connector pin definitions SignalCommand name Command code in hex Supported ATA commandsSupported ATA commands F4H Word Description Value Identify Device commandXx07H Bit Word Description if bit is set to Bit WordWord Set Features command values Set Features commandCode in features register A.R.T. command 3 S.M.A.R.T. commandsA.R.T. commands Technical Support Seagate Technology support servicesPresales Support Data Recovery Services Call Center Toll-free Direct dial Warranty ServiceData Recovery Services Authorized Service Centers Index ITE Page Pipeline HD Pro Serial ATA Product Manual, Rev. C Page Disc Drive, Scotts Valley, California 95066-4544, USA