Seagate ST9600204SS SAS-2 Specification compliance, Additional information, LED drive signal

Page 72

The Ready LED Out signal is designed to pull down the cathode of an LED. The anode is attached to the proper +3.3 volt supply through an appropriate current limiting resistor. The LED and the current limiting resis- tor are external to the drive. See Table 15 for the output characteristics of the LED drive signals.

Table 15:	LED drive signal

State		Test condition	Output voltage

LED off, high		0 V ≤VOH ≤3.6 V	-100 µA < IOH < 100 µA
LED on, low		IOL = 15 mA	0 ≤VOL ≤0.225 V

10.5.2Differential signals

The drive SAS differential signals comply with the intra-enclosure (internal connector) requirements of the SAS standard.

Table 16 defines the general interface characteristics

Table 16: General interface characteristics

Characteristic	Units	1.5Gb/s	3.0Gb/s	6.0Gb/s

Bit rate (nominal)	Mbaud	1,500	3,000	6,000

Unit interval (UI)(nominal)	ps	666.6	333.3	166.6

Impedance (nominal, differential )	ohm	100	100	100

Transmitter transients, maximum	V	± 1.2	± 1.2	± 1.2

Receiver transients, maximum	V	± 1.2	± 1.2	± 1.2

10.6SAS-2 Specification compliance

Seagate SAS-2 drives are entirely compatible with the latest SAS-2 Specification (T10/1760-D) Revision 16.

The most important characteristic of the SAS-2 drive at 6Gb/s is that the receiver is capable of adapting the equalizer to optimize the receive margins. The SAS-2 drive has two types of equalizers:

1.A Decision Feedback Equalizer (DFE) which utilizes the standard SAS-2 training pattern transmitted dur- ing the SNW-3 training gap. The DFE circuit can derive an optimal equalization characteristic to compen- sate for many of the receive losses in the system.

2.A Feed Forward Equalizer (FFE) optimized to provide balanced receive margins over a range of channels bounded by the best and worst case channels as defined by the relevant ANSI standard.

10.7Additional information

Please contact your Seagate representative for SAS electrical details, if required.

For more information about the Phy, Link, Transport, and Applications layers of the SAS interface, refer to the Seagate SAS Interface Manual, part number 100293071.

For more information about the SCSI commands used by Seagate SAS drives, refer to the Seagate SCSI Commands Reference Manual, part number 100293068.

64	Savvio 10K.4 SAS Product Manual, Rev. A

Image 72

Contents ST9600204SSST9600104SS ST9450404SSST9450304SS Standard Models Self-Encrypting Drive ModelsRevision history Rev. a 12/15/09 Initial releaseContents Defect and error management InstallationAbout self-encrypting drives Interface requirementsSeagate Technology support services Savvio 10K.4 SAS Product Manual, Rev. a List of Figures Page Scope Applicable standards and reference documentation StandardsElectromagnetic compatibility Electromagnetic susceptibilityElectromagnetic compliance Electromagnetic compliance for the European UnionAustralian C-Tick Korean KCCReference documents European Union Restriction of Hazardous Substances RoHSGeneral description Standard features Media descriptionPerformance ReliabilityFormatted capacities Programmable drive capacityFactory-installed options Performance characteristics Internal drive characteristicsSeek performance characteristics Access timeGeneral performance characteristics Start/stop timePrefetch/multi-segmented cache control Cache operationCaching write data Prefetch operation Reliability specifications Error ratesRecoverable Errors Unrecoverable ErrorsReliability and service Seek errorsInterface errors Preventive maintenanceMaximum processing delay Fully-enabled delay 4 S.M.A.R.TControlling S.M.A.R.T Performance impactTemperature Log Page 0Dh Parameter Code Description Predictive failuresThermal monitor State of the drive prior to testing Drive Self Test DSTDST failure definition ImplementationShort and extended tests Short test Function Code 001bExtended test Function Code 010b Log page entriesProduct warranty ShippingProduct repair and return information Physical/electrical specifications PowerChoiceTM power managementPowerChoice modes AC power requirements DC power requirementsSavvio 10K.4 SAS Product Manual, Rev. a Page Page General DC power requirement notes Power sequencingConducted noise immunity Current profiles Current profiles for 600GB modelsCurrent profiles for 450GB models Power dissipation GB models in 3Gb operation600GB models in 6Gb operation 450GB models in 3Gb operation Temperature a. Operating Environmental limits450GB models in 6Gb operation Relative humidity Effective altitude sea level a. OperatingShock and vibration Shock Recommended mounting Air cleanliness Vibration a. Operating-normalCorrosive environment Acoustics Mechanical specifications Mounting configuration dimensionsControlled access Admin SPAbout self-encrypting drives Data encryptionDefault password Random number generator RNGDrive locking Data bandsAuthenticated firmware download Power requirementsSupported commands Cryptographic eraseDefect and error management Drive internal defects/errorsDrive error recovery procedures SAS system errors Background Media Scan Media Pre-ScanDeferred Auto-Reallocation Idle Read After Write Installation Drive orientationCooling Air flowDrive mounting GroundingSAS features Interface requirementsDual port support Scsi commands supported Supported commandsSupported commands Supported commands Supported commands Mode Sense data Inquiry dataSavvio inquiry data Page Mode Sense data for ST9600204SS and ST9600104SS drives Mode PagesMode Sense values for ST9450404SS and ST9450304SS drives Miscellaneous operating features and conditions Miscellaneous featuresMiscellaneous status SAS physical interface Datum B Section C C Section a a Physical characteristics Connector requirementsElectrical description Pin descriptionsSignal characteristics PowerSAS transmitters and receivers Ready LED OutSAS-2 Specification compliance LED drive signalDifferential signals General interface characteristicsSeagate Technology support services InternetPresales Support Technical SupportWarranty Service Data Recovery Services Authorized Service CentersData Recovery Services Call Center Toll-free Direct dialFAX Index NumericsKCC Msid Mtbf See also cooling Page Savvio 10K.4 SAS Product Manual, Rev. a Page Seagate Technology LLC

Related manuals

Manual 82 pages 44.39 Kb