Seagate Lyrion Series manual Power specifications

Page 13

2.7Power specifications

The drive receives DC power (+3.3V) through the ZIF connector (CE-ATA interface).

2.7.1Power consumption

Power requirements for the drives are listed in the table on page 8. Typical power measurements are based on an average of drives tested, under nominal conditions, using +3.3V input voltage at 25°C ambient temperature.

•Startup mode

Startup power is measured from the time of power-on to the time that the drive spindle reaches operating speed.

•Seek mode

During seek mode, the read/write actuator arm moves toward a specific position on the disc surface and does not execute a read or write operation. Servo electronics are active. Seek power is measured based on three random seek operations every 100 msecs.

•Read/write mode

Read/write power is measured with the heads on track, while the head is reading/writing from/to disc. It is performed with 100 percent duty cycle of read/write operation.

•Performance Idle mode

During Performance Idle mode, the heads are on track but no reading or writing is done. The spindle motor is spinning at full speed.

•Low power idle mode

During Low power Idle mode, the heads are unloaded but the spindle motor is spinning at full speed. Servo and read/write electronics are in powered down mode.

•Standby / Sleep mode

During Standby/Sleep mode, the spindle motor is not spinning, and the servo and read/write electronics are in powered down mode.

Lyrion CE-ATA Product Manual, Rev. A

7

Page 12 Page 14
Image 13
Page 12 Page 14
Contents ST760211CA ST730212CA Lyrion Series CE-ATARevision Date Revision historyContents Lyrion CE-ATA Product Manual, Rev. a List of Figures Lyrion CE-ATA Product Manual, Rev. a Lyrion Series CE-ATA interface disc drive IntroductionDrive care DisclaimerSpecifications Drive specificationsDrive specification ST760211CA ST730212CA OverviewSpecifications LBA mode addressing Default logical geometryFormatted capacity Model Cylinders Heads SectorsTechnology Specification Physical characteristicsRecording and interface technology Time to readyPower specifications Power Consumption at Average W DC powerTypical current profile Voltage tolerance Voltage tolerance including noise Conducted noiseActive mode Power-management modesStandby/Sleep mode Power modes Heads Spindle BufferEnvironmental specifications Operating shock ShockNonoperating shock VibrationOperating random vibration Operating sweep sine vibrationOperating random vibration profile Nonoperating sweep sine vibrationNonoperating random vibration profile Nonoperating random vibrationCorrosive environment Electromagnetic immunity AcousticsDrive level acoustics Electromagnetic immunityReliability Measurement type SpecificationAgency certification Safety certificationElectromagnetic compatibility Korean RRLFCC verification China Restriction of Hazardous Substances RoHS DirectivePage Lyrion CE-ATA Product Manual, Rev. a Handling and static discharge precautions Configuring and mounting the drivePage Lyrion Series mechanical dimensions-top, side and end view Drive installationMounting considerations Lyrion Series FPC dimensionsWay ZIF CE-ATA interface connector signals Interface signals and connector pinsPin number Signal Name Definition Interface descriptionMMC command set Supported command set and featuresReduced ATA command set Supported commands Command Index Command Name Command DescriptionIdentify Device commands Identify Device commandWord Description Value Index Byte Address Name Description Status and Control RegistersByte Name Detailed description Address Internet Seagate Technology support servicesPresales Support Technical SupportData Recovery Services Authorized Service Centers Warranty ServiceData Recovery Services Call Center Toll-free Direct dial Index Page Page Seagate Technology LLC

Lyrion Series specifications

The Seagate Lyrion Series is an innovative line of storage solutions designed to meet the high-performance demands of data-intensive applications. As data continues to proliferate across industries, the need for reliable, efficient, and scalable storage solutions becomes paramount. The Lyrion Series addresses this need by offering advanced technologies and characteristics that set it apart in the competitive storage market.

One of the standout features of the Lyrion Series is its impressive speed and performance. Leveraging cutting-edge Solid-State Drive (SSD) technology, these drives significantly reduce latency and enhance data access speeds compared to traditional Hard Disk Drives (HDDs). This performance boost is especially beneficial for applications that require rapid data retrieval and processing, such as virtualization, big data analytics, and real-time data processing.

Another key characteristic of the Seagate Lyrion Series is its capacity for high scalability. These drives are designed to accommodate the growing demands of modern storage environments, making them suitable for enterprises with evolving data needs. The Lyrion Series provides a range of capacities, enabling businesses to scale their storage solutions seamlessly as their data requirements expand.

Furthermore, the Lyrion Series incorporates advanced security features, ensuring that sensitive data is protected against unauthorized access. With built-in encryption options, businesses can rest assured that their information remains secure while being stored or transmitted. This is particularly crucial in industries that handle confidential data, such as finance, healthcare, and government.

The durability of the Seagate Lyrion Series also deserves attention. Designed for longevity and reliability, these drives offer robust performance in demanding conditions. They are built to withstand operational stress and provide consistent performance over time, minimizing downtime and ensuring that critical data is always accessible.

In addition to these core features, the Lyrion Series is engineered for energy efficiency. By minimizing power consumption, these drives not only reduce operational costs but also contribute to a greener IT infrastructure. This focus on sustainability aligns with the increasing global emphasis on reducing carbon footprints and promoting environmentally friendly practices.

In summary, the Seagate Lyrion Series is a versatile and powerful storage solution that combines speed, scalability, security, durability, and energy efficiency. These characteristics make it an ideal choice for businesses across various sectors looking to manage their data more effectively. As the digital landscape continues to evolve, the Lyrion Series stands as a testament to Seagate’s commitment to innovation and excellence in data storage technology.
Top Page Image Contents