70 | Cheetah 36XL Product Manual, Rev. E |
Output characteristics
Each signal (Vs) driven by LVD interface drivers shall have the following output characteristics when measured at the disc drive connector:
Steady state Low level output voltage* =
*These voltages shall be measured between the output terminal and the SCSI device’s logic ground reference.
The output characteristics shall additionally conform to EIA
STEADY STATE | 100Ω | ||
V1 | |||
| |||
LOGIC INPUT |
| ||
|
| ||
(1 OR 0) |
|
| |
D | Vs | 75Ω | |
|
| 100Ω | |
| +SIGNAL | V2 | |
|
|
MEASURED
PARAMETER
DEVICE CONNECTOR
Figure 24. LVD output signals
Input characteristics
Each signal (Vs) received by LVD interface receiver circuits shall have the following input characteristics when measured at the disk drive connector:
Steady state Low level output voltage* = 0.030 V = < Vs = < 3.6 V (signal negation/logic 0) Steady state High level output voltage* =
Differential voltage = +0.30 V minimum with
*These voltages shall be measured between the output terminal and the SCSI device’s logic ground reference.
Input characteristics shall additionally conform to EIA
| VCCA |
| VCCB |
Single | LVD Signal Drivers | Single | Single |
| |||
Ended |
| Ended | Ended |
Circuitry |
| Receiver | Negation |
| LVD |
| Driver |
|
|
| |
| Receiver |
|
|
Single |
|
| Single |
Ended |
|
| Ended |
Ground |
|
| Assertion |
Driver |
|
| Driver |
| LVD Signal Drivers |
|
|
Ground |
|
|
|
Single Ended: | GND | |
LVD: | +Signal |