Seagate ST320410ACE manual Humidity 3.1 Relative Humidity, Wet bulb temperature, Altitude, Shock

Page 20

12U Series CE Family Product Manual, Rev. A

1.8.3 Humidity
1.8.3.1	Relative Humidity
Operating		5% to 90% noncondensing (30% per hour max)
Nonoperating		5% to 95% noncondensing (30% per hour max)
1.8.3.2	Wet bulb temperature
Operating		29.4°C (84°F) max
Nonoperating		40.0°C (104°F) max
1.8.4 Altitude
Operating		–60.96 m to 3,048 m (–200 ft to 10,000+ ft)
Nonoperating		–121.92 m to 12,192 m (–400 ft to 40,000+ ft)

1.8.5 Shock

All shock specifications assume that the drive is mounted securely with the input shock applied at the drive mounting screws. Shock may be applied in the X, Y or Z axis.

1.8.5.1 Operating shock

These drives comply with the performance levels specified in this docu- ment when subjected to a maximum operating shock of 63 Gs (based on half-sine shock pulses of 2 msec). Shocks should not be repeated more than two times per second.

1.8.5.2 Nonoperating shock

The nonoperating shock level that the drive can experience without incurring physical damage or degradation in performance when subse- quently put into operation is 350 Gs (based on nonrepetitive half-sine shock pulses of 1 and 2 msec duration).

1.8.6 Vibration

All vibration specifications assume that the drive is mounted securely with the input vibration applied at the drive mounting screws. Vibration may be applied in the X, Y or Z axis.

Image 20

Contents Series CE Family Page Series CE Family Page Contents Configuring and mounting the drive ATA interfaceFigures Series CE Family Product Manual, Rev. a Introduction Specification summary table Track-to-track seek Time msec typical Altitude meters be Low mean sea level Formatted capacity Default logical geometryLBA Mode Recording and interface technology Physical characteristicsPhysical organization Seek time Start/stop timesPower specifications Power consumptionPower Mode Typical Watts Typical Amps Means 12V Typical current profileVoltage tolerance Power-management modesConducted noise Environmental tolerances Ambient temperature Temperature gradientSleep mode Idle and Standby timers3.2 Wet bulb temperature Humidity 3.1 Relative HumidityAltitude ShockDrive acoustics Operating vibrationNonoperating vibration Reliability Agency certification 1.12.1 Safety certificationElectromagnetic immunity Korean RRL Electromagnetic compatibilityTaiwan Bsmi FCC verification Australian C-Tick N176Configuring and mounting the drive Handling and static-discharge precautionsOptions jumper block Jumper settings Master/slave configurationDrive as master with a non-ATA-compatible slave Ultra ATA/100 cable Cable-select optionAlternate capacity jumper Recommended Case temperature Measurement location Drive mountingATA interface signals and connector pins ATA interfaceO pins and supported ATA signals Supported ATA commands Command name Command code in hex ATA-standard commandsIdentify Drive command Command nameATA-standard power-management commands ATA-standard security commandsWord Description 0C5AHWord Description Value Xx07HXx3FH Description if bit is set to Bit Word Bit WordSet Features command 0AH 4 S.M.A.R.T. commands Code in Features A.R.T. Command RegisterSeries CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a