Seagate ST320410ACE, ST380020ACE, ST340810ACE, ST360020ACE Altitude meters be Low mean sea level

Page 12

4	U Series CE Family Product Manual, Rev. A

Drive Specification	ST380020ACE	ST360020ACE	ST340810ACE	ST320410ACE


Altitude (meters be-
low mean sea level,	–121.92 m to 12,192 m (–400 ft to 40,000+ ft)
max)	–121.92 m to 12,192 m (–400 ft to 40,000+ ft)

Shock, operating
(Gs max at 2 msec)		63 Gs

Shock, nonoperating
(Gs max at 1 and 2
msec)		350 Gs

Vibration, operating		0.5 Gs (0 to peak, 22–350 Hz)

Vibration,
nonoperating		5 Gs (0 to peak, 22–350 Hz)

Drive acoustics
Sound power in bels
Idle mode		2.7 (typical), 3.0 (max)
Performance Seek		2.9 (typical), 3.2 (max)

Nonrecoverable		1 per 1013 bits read
read errors		1 per 1013 bits read
Mean time between
failures (power-on
hours)	600,000

Contact start-stop cy-
cles (25°C, 40%
relative humidity)	50,000

SeaShield		Yes

Image 12

Contents Series CE Family Page Series CE Family Page Contents Configuring and mounting the drive ATA interfaceFigures Series CE Family Product Manual, Rev. a Introduction Specification summary table Track-to-track seek Time msec typical Altitude meters be Low mean sea level Default logical geometry LBA ModeFormatted capacity Physical characteristics Physical organizationRecording and interface technology Seek time Start/stop timesPower specifications Power consumptionPower Mode Typical Watts Typical Amps Means 12V Typical current profilePower-management modes Conducted noiseVoltage tolerance Environmental tolerances Ambient temperature Temperature gradientSleep mode Idle and Standby timers3.2 Wet bulb temperature Humidity 3.1 Relative HumidityAltitude ShockOperating vibration Nonoperating vibrationDrive acoustics Agency certification 1.12.1 Safety certification Electromagnetic immunityReliability Electromagnetic compatibility Taiwan BsmiKorean RRL FCC verification Australian C-Tick N176Configuring and mounting the drive Handling and static-discharge precautionsJumper settings Master/slave configuration Drive as master with a non-ATA-compatible slaveOptions jumper block Cable-select option Alternate capacity jumperUltra ATA/100 cable Recommended Case temperature Measurement location Drive mountingATA interface signals and connector pins ATA interfaceO pins and supported ATA signals Supported ATA commands Command name Command code in hex ATA-standard commandsIdentify Drive command Command nameATA-standard power-management commands ATA-standard security commandsWord Description 0C5AHWord Description Value Xx07HXx3FH Description if bit is set to Bit Word Bit WordSet Features command 0AH 4 S.M.A.R.T. commands Code in Features A.R.T. Command RegisterSeries CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a