Seagate ST320410ACE, ST380020ACE, ST340810ACE, ST360020ACE Description if bit is set to Bit Word

Page 36

28	U Series CE Family Product Manual, Rev. A

Word	Description	Value


92	Master Password Revision	FFFEH
	code

93	Hardware Reset Value	xxxxH
	(see description following
	this table)

94	Auto Acoustic Management	xxxxH
	Setting

95–127	ATA-reserved	0000H

128	Security Status	0001H

129–	Seagate-reserved	xxxxH
159

160–	ATA-reserved	0000H
254

255	Integrity word	xxA5H

Note. See the bit descriptions below for words 63, 88 and 93 of the Identify Drive data:

Description (if bit is set to 1)

Bit

Word 63

0Multiword DMA mode 0 is supported.

1Multiword DMA mode 1 is supported.

2Multiword DMA mode 2 is supported.

8Multiword DMA mode 0 is currently active.

9Multiword DMA mode 1 is currently active.

10Multiword DMA mode 2 is currently active.

Bit

Word 88

0Ultra DMA mode 0 is supported.

1Ultra DMA mode 1 is supported.

2Ultra DMA mode 2 is supported.

Image 36

Contents Series CE Family Page Series CE Family Page Contents Configuring and mounting the drive ATA interfaceFigures Series CE Family Product Manual, Rev. a Introduction Specification summary table Track-to-track seek Time msec typical Altitude meters be Low mean sea level Default logical geometry LBA ModeFormatted capacity Physical characteristics Physical organizationRecording and interface technology Seek time Start/stop timesPower specifications Power consumptionPower Mode Typical Watts Typical Amps Means 12V Typical current profilePower-management modes Conducted noiseVoltage tolerance Environmental tolerances Ambient temperature Temperature gradientSleep mode Idle and Standby timers3.2 Wet bulb temperature Humidity 3.1 Relative HumidityAltitude ShockOperating vibration Nonoperating vibrationDrive acoustics Agency certification 1.12.1 Safety certification Electromagnetic immunityReliability Electromagnetic compatibility Taiwan BsmiKorean RRL FCC verification Australian C-Tick N176Configuring and mounting the drive Handling and static-discharge precautionsJumper settings Master/slave configuration Drive as master with a non-ATA-compatible slaveOptions jumper block Cable-select option Alternate capacity jumperUltra ATA/100 cable Recommended Case temperature Measurement location Drive mountingATA interface signals and connector pins ATA interfaceO pins and supported ATA signals Supported ATA commands Command name Command code in hex ATA-standard commandsIdentify Drive command Command nameATA-standard power-management commands ATA-standard security commandsWord Description 0C5AHWord Description Value Xx07HXx3FH Description if bit is set to Bit Word Bit WordSet Features command 0AH 4 S.M.A.R.T. commands Code in Features A.R.T. Command RegisterSeries CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a