Seagate ST340810ACE, ST320410ACE, ST380020ACE, ST360020ACE manual Word Description Value, Xx07H

Page 34

26	U Series CE Family Product Manual, Rev. A

Word	Description	Value


50	Device-specific standby	0000H
	timer value

51	PIO data-transfer cycle
	timing mode	0200H
52	Retired	0200H

53	Words 54–58, 64–70 and 88
	are valid	0007H
54	Number of current logical	xxxxH
	cylinders

55	Number of current logical	xxxxH
	heads

56	Number of current logical	xxxxH
	sectors per logical track	xxxxH

57–58	Current capacity in sectors	xxxxH

59	Number of sectors trans-	xxxxH
	ferred during a Read Multiple	xxxxH
	or Write Multiple command

60–61	Total number of user-addres-	ST380020ACE = 160,045,200
	sable LBA sectors available	ST360020ACE = 120,033,900
	(see Section 2.2.3 for related	ST340810ACE = 80,022,600
	(see Section 2.2.3 for related	ST320410ACE = 40,011,300
	information)	ST320410ACE = 40,011,300
	information)

62	Retired	0000H

63	Multiword DMA active and	xx07H
	modes supported (see note
	following this table)

64	Advanced PIO modes sup-
	ported (modes 3 and 4 sup-	0003H
	ported)

65	Minimum multiword DMA
	transfer cycle time per word	0078H
	(120 nsec)

Image 34

Contents Series CE Family Page Series CE Family Page Contents Configuring and mounting the drive ATA interfaceFigures Series CE Family Product Manual, Rev. a Introduction Specification summary table Track-to-track seek Time msec typical Altitude meters be Low mean sea level LBA Mode Default logical geometryFormatted capacity Physical organization Physical characteristicsRecording and interface technology Seek time Start/stop timesPower specifications Power consumptionPower Mode Typical Watts Typical Amps Means 12V Typical current profileConducted noise Power-management modesVoltage tolerance Sleep mode Environmental tolerances Ambient temperatureTemperature gradient Idle and Standby timersAltitude 3.2 Wet bulb temperatureHumidity 3.1 Relative Humidity ShockNonoperating vibration Operating vibrationDrive acoustics Electromagnetic immunity Agency certification 1.12.1 Safety certificationReliability Taiwan Bsmi Electromagnetic compatibilityKorean RRL FCC verification Australian C-Tick N176Configuring and mounting the drive Handling and static-discharge precautionsDrive as master with a non-ATA-compatible slave Jumper settings Master/slave configurationOptions jumper block Alternate capacity jumper Cable-select optionUltra ATA/100 cable Recommended Case temperature Measurement location Drive mountingATA interface signals and connector pins ATA interfaceO pins and supported ATA signals Supported ATA commands Command name Command code in hex ATA-standard commandsATA-standard power-management commands Identify Drive commandCommand name ATA-standard security commandsWord Description 0C5AHWord Description Value Xx07HXx3FH Description if bit is set to Bit Word Bit WordSet Features command 0AH 4 S.M.A.R.T. commands Code in Features A.R.T. Command RegisterSeries CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a