18 | U Series CE Family Product Manual, Rev. A |
2.2 Jumper settings
2.2.1 Master/slave configuration
The options jumper block shown in Figure 2 is used to configure the drive for operation. It is the
Master or single drive. The drive is configured at the factory for a master or
Drive as slave. Remove all jumpers.
Drive as master with a non-ATA-compatible slave.
Set a jumper on pins 5 and 6 and a jumper on pins 7 and 8. Use this jumper setting only if the drive does not work as a master with no jumpers installed.
Options jumper block
Master or single drive
Drive is slave
Master with non ATA- compatible slave
Cable select
Limit drive capacity
>32 Gbytes = 32 Gbytes <32 Gbytes = 2.1 Gbytes
7 5 3 1
8 6 4 2
Circuit Board