Seagate ST320410ACE Identify Drive command, Command name, ATA-standard power-management commands

Page 32

24	U Series CE Family Product Manual, Rev. A

Command name		Command code (in hex)

Write Multiple		C5H

Write Sectors		30H, 31H

ATA-standard power-management commands

Check Power Mode		98H or E5H
Idle		97H or E3H

Idle Immediate		95H or E1H

Sleep		99H or E6H

Standby		96H or E2H

Standby Immediate		94H or E0H

ATA-standard security commands

Security Set Password		F1H

Security Unlock		F2H

Security Erase Prepare		F3H

Security Erase Unit		F4H

Security Freeze Lock		F5H

Security Disable Password		F6H

3.1.2 Identify Drive command

The Identify Drive command (command code ECH) transfers information about the drive to the host following power up. The data is organized as a single 512-byte block of data, whose contents are shown in the table on page 25. All reserved bits or words should be set to zero. Parameters listed with an “x” are drive-specific or vary with the state of the drive. See Section 1 of this manual for default parameter settings.

The following commands contain drive-specific features that may not be included in the Draft ATA-Rev 6 Standard.

Image 32

Contents Series CE Family Page Series CE Family Page Contents Configuring and mounting the drive ATA interfaceFigures Series CE Family Product Manual, Rev. a Introduction Specification summary table Track-to-track seek Time msec typical Altitude meters be Low mean sea level Formatted capacity Default logical geometryLBA Mode Recording and interface technology Physical characteristicsPhysical organization Seek time Start/stop timesPower specifications Power consumptionPower Mode Typical Watts Typical Amps Means 12V Typical current profileVoltage tolerance Power-management modesConducted noise Environmental tolerances Ambient temperature Temperature gradientSleep mode Idle and Standby timers3.2 Wet bulb temperature Humidity 3.1 Relative HumidityAltitude ShockDrive acoustics Operating vibrationNonoperating vibration Reliability Agency certification 1.12.1 Safety certificationElectromagnetic immunity Korean RRL Electromagnetic compatibilityTaiwan Bsmi FCC verification Australian C-Tick N176Configuring and mounting the drive Handling and static-discharge precautionsOptions jumper block Jumper settings Master/slave configurationDrive as master with a non-ATA-compatible slave Ultra ATA/100 cable Cable-select optionAlternate capacity jumper Recommended Case temperature Measurement location Drive mountingATA interface signals and connector pins ATA interfaceO pins and supported ATA signals Supported ATA commands Command name Command code in hex ATA-standard commandsIdentify Drive command Command nameATA-standard power-management commands ATA-standard security commandsWord Description 0C5AHWord Description Value Xx07HXx3FH Description if bit is set to Bit Word Bit WordSet Features command 0AH 4 S.M.A.R.T. commands Code in Features A.R.T. Command RegisterSeries CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a Series CE Family Product Manual, Rev. a