Seagate ST360019A manual Mounting dimensions-top, side and end view

Page 29

Notes:

1.Dimensions are shown in inches (mm).

2Dimensions per SFF-8301 specification.

Recommended case temperature measurement location

				0.228
1.028 max				(5.79)
1.028 max
(26.11)
3 x 0.25		0.015
(6.35	0.037)
both sides
1.122	0.02		2
(28.5	0.51)		2
(28.5	0.51)
1.638	0.01
(41.61	0.25)			5.787 max
				(146.99)
		4.0		0.01
	(101.60			0.25)
3 x 6-32 UNC-2B
0.225 (5.72) max. fastener
penetration both sides. 3 threads
minimum engagement.

2.23			0.178
(56.56)			(4.27)
2.83
(71.80)
	3.71
	(94.35)
			1.625	0.02
			(41.28	0.51)
			1.75	0.01
			(44.45	0.25)
			4 x 6-32 UNC-2B
			0.250 (6.35) max. fastener
			penetration. 3 threads
			minimum engagement.
0.125	0.01		Recommended
(3.18	0.25)		Recommended
	3.75	0.01	case temperature
	3.75	0.01	measurement location
(95.25		0.25)
	4.0	0.01
(101.60		0.25)

Figure 1. Mounting dimensions—top, side and end view

U Series 9 Product Manual, Rev. D

19

Image 29

Contents Series Page Series Page Revision status summary sheet Page Contents Series 9 Product Manual, Rev. D List of Figures Viii Series 9 Product Manual, Rev. D Introduction Series 9 Product Manual, Rev. D Specification summary table Drive specificationsSeries 9 Product Manual, Rev. D LBA mode Default logical geometryFormatted capacity Physical organizationPower specifications Physical characteristicsSeek time Start/stop timesSpinup power Power consumptionSeek mode Read/write power and currentTypical 5V startup and operation current profile Typical current profileActive mode Power-management modesIdle mode Sleep modeEnvironmental specifications Acoustics Fluid Dynamic Bearing FDB motor acoustics Electromagnetic immunityReliability Agency certification Page Handling and static discharge precautions Configuring and mounting the driveBreather filter hole location Breather filter hole precautionsMaster/slave configuration Jumper settingsDrive as master with a non-ATA-compatible slave Cable-select optionUltra ATA/100 cable Drive mountingMounting dimensions-top, side and end view Series 9 Product Manual, Rev. D ATA interface ATA interface signals and connector pinsO pins and supported ATA signals Command name Command code in hex ATA-standard commands Supported ATA commandsCommand name Command code in hex Word Description Value Identify Device commandXx07H Description if bit is set to Bit Word 0CH Set Features commandCode in features A.R.T. command Register 4 S.M.A.R.T. commandsSeries 9 Product Manual, Rev. D Internet Seagate Technology support servicesMySeagate Reseller MarketplaceAuthorized Service Centers Warranty ServiceSeagate Online Store Presales SupportUSA/Canada/Latin America Support Services FAX Services-All European Countries European Support ServicesAsia/Pacific Support Services Series 9 Product Manual, Rev. D Numerics IndexPage Page Series 9 Product Manual, Rev. D Page Seagate Technology LLC