Seagate ST360019A manual Description if bit is set to Bit Word

Page 37

Word	Description	Value

128	Security status	0001H
129–159	Seagate-reserved	xxxxH

160–254	ATA-reserved	0000H

255	Integrity word	xxA5H

Note. Advanced Power Management (APM) and Automatic Acoustic Management (AAM) features are not supported

Note. See the bit descriptions below for words 63, 88, and 93 of the Identify Drive data:

Description (if bit is set to 1)

	Bit	Word 63

	0	Multiword DMA mode 0 is supported.

	1	Multiword DMA mode 1 is supported.

	2	Multiword DMA mode 2 is supported.

	8	Multiword DMA mode 0 is currently active.

	9	Multiword DMA mode 1 is currently active.

	10	Multiword DMA mode 2 is currently active.

	Bit	Word 88

	0	Ultra DMA mode 0 is supported.

	1	Ultra DMA mode 1 is supported.

	2	Ultra DMA mode 2 is supported.

	3	Ultra DMA mode 3 is supported.

	4	Ultra DMA mode 4 is supported.

	8	Ultra DMA mode 0 is currently active.

	9	Ultra DMA mode 1 is currently active.

	10	Ultra DMA mode 2 is currently active.

	11	Ultra DMA mode 3 is currently active.

	12	Ultra DMA mode 4 is currently active.

	13	Ultra DMA mode 5 is currently active.

U Series 9 Product Manual, Rev. D

27

Image 37

Contents Series Page Series Page Revision status summary sheet Page Contents Series 9 Product Manual, Rev. D List of Figures Viii Series 9 Product Manual, Rev. D Introduction Series 9 Product Manual, Rev. D Specification summary table Drive specificationsSeries 9 Product Manual, Rev. D LBA mode Default logical geometryFormatted capacity Physical organizationPower specifications Physical characteristicsSeek time Start/stop timesSpinup power Power consumptionSeek mode Read/write power and currentTypical 5V startup and operation current profile Typical current profileActive mode Power-management modesIdle mode Sleep modeEnvironmental specifications Acoustics Reliability Electromagnetic immunityFluid Dynamic Bearing FDB motor acoustics Agency certification Page Handling and static discharge precautions Configuring and mounting the driveBreather filter hole location Breather filter hole precautionsMaster/slave configuration Jumper settingsDrive as master with a non-ATA-compatible slave Cable-select optionUltra ATA/100 cable Drive mountingMounting dimensions-top, side and end view Series 9 Product Manual, Rev. D ATA interface ATA interface signals and connector pinsO pins and supported ATA signals Command name Command code in hex ATA-standard commands Supported ATA commandsCommand name Command code in hex Word Description Value Identify Device commandXx07H Description if bit is set to Bit Word 0CH Set Features commandCode in features A.R.T. command Register 4 S.M.A.R.T. commandsSeries 9 Product Manual, Rev. D Internet Seagate Technology support servicesMySeagate Reseller MarketplaceAuthorized Service Centers Warranty ServiceSeagate Online Store Presales SupportUSA/Canada/Latin America Support Services FAX Services-All European Countries European Support ServicesAsia/Pacific Support Services Series 9 Product Manual, Rev. D Numerics IndexPage Page Series 9 Product Manual, Rev. D Page Seagate Technology LLC